Recent content by DurrtyBurB
-
Official oem/replica wheel thread
Stock Ram rims 18”’with All terrain tires.- DurrtyBurB
- Post #540
- Forum: Exterior
-
New to me 2010 GMC Denali
Interior seats are in rough shape. Ordered replacement lower covers but got the wrong ones. No cracks in dash and no fading paint.(No smalll feat due to the AZ sun) Will need a good interior scrub but , PO had small children. Full set of Weather tech mats were included. Michelin Defender Tires...- DurrtyBurB
- Post #7
- Forum: General Discussion
-
New to me 2010 GMC Denali
Picked up a 2010 GMC Denali over the weekend for 5k. Not the cheapest but body in good shape and good service history. First short wheel base version after owning nothing but LWB in the NBS/NNBS platforms. It does need a few things. Ordered replacement lower front seat covers and replacement...- DurrtyBurB
- Thread
- Replies: 7
- Forum: General Discussion
-
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
Completed an oil change and replaced the gasket on the oil cooler block off plate. Noticed a slight tick from the engine. This being a 08 6.2 I don’t believe it has the AFM lifters. I’ll have to take to valve covers off to see if it’s a sticky/collapsed lifter. If so might as well do both sides...- DurrtyBurB
- Post #40,644
- Forum: General Discussion
-
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
Back to the forum with a 08 Denali. Replaced the worn interior door handle, rear door lock actuator(too weak to unlock) and front passenger seat track. Previous owner had added front Escalade seats from 2010+. These were tripping the air bag light. Ended up just swapping the covers/foam on to...- DurrtyBurB
- Post #40,526
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Suburban decided to puke its guts out on the freeway. Limped it home. I’m in the middle of replacing coolant, radiator, quick connect on the heater core. Got the radiator from vatozone I did verify radiator comes with the restriction on the right tank. Have great heat up front not so much in the...- DurrtyBurB
- Post #39,014
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Shh:secret: don’t tell anybody:lol2:- DurrtyBurB
- Post #38,886
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Got this sucker in today. Waiting for the usb/serial adapter to arrive and finish set up. Itching to get these DIC buttons to finally work.- DurrtyBurB
- Post #38,881
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
I did not, I could not find any instructions that mentioned anything about the rear. I figured opening it up and resetting it to the middle setting like new actuator would do the trick.- DurrtyBurB
- Post #38,823
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
After the battery died front/rear actuators we’re all out of wack. Tried the calibration trick and it fixed all front actuators along with one of the rear actuators. The temperature one was stubborn and would not reset. Ended up uninstalling it , opened it up and reset to the middle position. I...- DurrtyBurB
- Post #38,818
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Battery died about 50 miles from home. Luckily a Costco was a few miles down the road. I usually carry at least a 8/10 mm wrench/socket/ratchet for emergencies . I was able to loosen up the 14 mm bolt for the battery tie down with some pliers.- DurrtyBurB
- Post #38,799
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Looks like the module the PO has for the head unit does not integrate the audio controls. For the DIC buttons DIC personalization is set to off. I assume that’s why those buttons don’t work. I may need to pull the trigger on a clone Tech 2 at this point. Started removing the side moldings, I...- DurrtyBurB
- Post #38,780
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Yeah code 922 Pewter Gray- DurrtyBurB
- Post #38,743
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Replaced the front seat cover. Seat pan edges is sharp AF. Color is way off though but I guess it’s to be expected since they are 16 year old seats and thousands of farts later. That may contribute to the color change- DurrtyBurB
- Post #38,741
- Forum: General Discussion
-
DIC buttons
Recently picked up a 2005 Suburban LT none of the 4 DIC buttons are working. None of the steering wheel controls illuminate either.- DurrtyBurB
- Thread
- dic
- Replies: 1
- Forum: Interior
