Dantheman-2003
Latest activity Postings About
-
-
Dantheman-2003 reacted to OR VietVet's post in the thread 03 Tahoe- Rear Differential Fluid Change: Questions with
Like.
No matter what, fill till the fluid runs out and then is full. Noticed a drip from where? The cover? The pinion seal? Which axle? I am... -
Dantheman-2003 reacted to nonickatall's post in the thread 03 Tahoe- Rear Differential Fluid Change: Questions with Like.
You can't overfill the differential, but you can drive with a lack of oil which is not good for your Differential rather then for your axle.
-
Dantheman-2003 reacted to rockola1971's post in the thread 03 Tahoe- Rear Differential Fluid Change: Questions with Like.
Some of that fluid will go down your axle tubes and wet them and the axle bearings in the tubes. Get that leak fixed! Blue loctite on...
-
Dantheman-2003 replied to the thread 03 Tahoe- Rear Differential Fluid Change: Questions.Yeah, slow small drip under the rear diff cover right at the bottom. Less that 1 drop per day so I ain’t too worried. Just keep an eye...
-
Dantheman-2003 replied to the thread 03 Tahoe- Rear Differential Fluid Change: Questions.@Sam Harris - Where did you purchase your girdled cover? Happy with it?
-
Dantheman-2003 reacted to Sam Harris's post in the thread 03 Tahoe- Rear Differential Fluid Change: Questions with Like.
I ended up somewhere around 3.25 quarts when I did my girdled diff cover. Not sure if the new cover had more capacity or not, but it...
-
Dantheman-2003 posted the thread 03 Tahoe- Rear Differential Fluid Change: Questions in Engine & Drivetrain.So I just re-geared my 03 Tahoe from 3:73 to 4:56. After 500 miles I changed my fluids. The front diff took about 1.5 quarts, which it...
-
Dantheman-2003 replied to the thread 03 Tahoe Code P0116- FIXED.UPDATE: So I disconnected the battery, went back through the wiring, and now all good. Everything working as it should. E-fans engage at...
-
Dantheman-2003 replied to the thread 03 Tahoe Code P0116- FIXED.Yeah for sure that code points to the temp sensor. But I never messed with it. Never touched it. Ima take a look today and will circle back.
-
Dantheman-2003 replied to the thread 03 Tahoe Code P0116- FIXED.I’ll take another look today. Pretty basic setup. OEM harness, blue/black & grey/ yellow to fans. Red to power, black to ground. 2 PCM...
-
Dantheman-2003 replied to the thread 03 Tahoe Code P0116- FIXED.
-
So I just finished my electric fan conversion on the Tahoe. Installed the Blackbear performance tune. Everything seems to work fine...
-
Also for soldering wire, use a good sized powerful iron/gun instead of the pencil tip deal and have a blob of melted solder on the tip...
-
Electric fans are relatively high amperage devices so their wiring needs to be on point. Solder is best, but only if done correctly...
-
Dantheman-2003 replied to the thread E-Fan Wire, Solder or Connectors?.@adriver. Exactly the feedback I was looking for. Pretty terrible work. Big nasty booger welds. I ordered some Wego connectors and am...
-
-
Loading…
-
Loading…
