Recent content by ChsCountyYukon

  1. C

    05 Yukon ABS Pump Corroded

    I thought I would add in a helpful tip plus I found some pictures on my phone. I did this job on the ground without a lift. When changing out the rear center flex lines above the rear axle, access is close to impossible. Remove the two brackets that hold the lines in place. You can get access...
  2. C

    Stabilitrak and traction control warnings on ‘07 Yukon

    I have a Autel AL619 that I used to read the ABS / SRS codes off my 05 Yukon without any issue. Less then $100 and it works on all of my cars with ABS. Free updates as well
  3. C

    05 Yukon ABS Pump Corroded

    The passenger side hub was aftermarket. Part # 515036. Made by MOOG. This part is at least 8 years old with 80K miles on it. I replaced the hub with one that already had a speed sensor installed. No more ABS lights and Stabilitrak lights are off. The old hub seemed fine. There was no play...
  4. C

    05 Yukon ABS Pump Corroded

    Here is where I am at. The front passenger side hub is not original previous owner must have replaced it. It had shims and that is not OEM. When I look in the ABS hole it is clean and I can see the tone ring. I pulled the speed sensor on the driver side (no shims) and looked in the hole. It...
  5. C

    05 Yukon ABS Pump Corroded

    The ABS pump was replaced. I had to bleed twice to get a firm pedal, it is now perfect. I can now communicate to the ABS module. I was unable to communicate before. Here is the latest issue. During this repair job I replaced the right front speed sensor due to an error code before any of...
  6. C

    05 Yukon ABS Pump Corroded

    Because I had to know I pulled the metal cover off the ABS module. I used a heat gun and razor blades and I still had to hack the surrounding plastic lip up. There is evidence of water damage. Although it is a sealed unit there is a passage on the bottom of the unit that would allow water...
  7. C

    05 Yukon ABS Pump Corroded

    I am going to buy the pump and module off ebay used. Is that a plug and play deal? Or do I need to have the ABS reprogrammed at the dealer? My original module is shot.
  8. C

    05 Yukon ABS Pump Corroded

    Hello All. New here. I am working on a 05 Yukon Denali XL 1500 150K. This nightmare started with rusted out brake lines with the ABS / brake light on. I pulled the entire ABS pump out thinking I could just rebuild the module and I ran into a totally corroded pump. The module actually swelled...
See more

Forum statistics

Threads
137,766
Posts
1,991,615
Members
102,756
Latest member
dizhai

Latest posts

Back
Top