Recent content by BPopilek

  1. BPopilek

    What is this???

    I believe that is normally a temperature sensor for the hvac controls. Sent from my iPhone using Tapatalk Pro
  2. BPopilek

    What is this???

    Yes that is the OnStar microphone. If you are deleting OnStar, then it's a good spot to use. Sent from my iPhone using Tapatalk Pro
  3. BPopilek

    4L60 to 4L80e Swap

    So far I love it! The power is a night and day difference from the stock 5.3/4L60 combo. I'm still running the stock 4L80e converter for now with a 2400 stall. Might change that later on. I lucked out and the tranny I got only had about 60k miles on it. May need a rebuild at some time, but for...
  4. BPopilek

    4L60 to 4L80e Swap

    Thanks. I got this figured out about a day after my post. Been driving it around and enjoying the increased power! All the figures point to about 550hp. Still have to get it on a dyno at some point to confirm. Also plan on adding a turbo later this spring / summer. Sent from my iPhone using...
  5. BPopilek

    6.0 Swap DIC Question

    So a couple of weeks ago, I finally finished installing my fully rebuilt 6.0L LQ4 with LS3 heads, custom CAM, 2014 Camaro intake/fuel injectors, shorty headers, and 4L80e transmission. I had a very reputable shop write my tune (CHenry Motorsports) for my HP Tuner, and it is running awesome! So...
  6. BPopilek

    4L60 to 4L80e Swap

    Well I ended up making a custom mount using my existing cross member. I had the transmission mount from the 2000 Silverado that I used part of to make it happen. Fits in the factory position and should be much stronger than some of the others I have seen made. I also found a driveshaft at the...
  7. BPopilek

    4L60 to 4L80e Swap

    I'm in the process of installing a fully rebuilt 6.0L in my 2008 Yukon. As part of this swap, I'm replacing the weak 4L60 with a 4L80e. I have the harness adapter already. With everything pulled out, I measured a length of 27" from the transfer case adapter to the edge of the bell housing on the...
  8. BPopilek

    Did the Denali ever come with heated wind shield wiper fluid?

    I did call them today. The GM version is a drop in replacement for the factory one that was removed. The OD version is for aftermarket only. Since they are only about 30 minutes from my house, they said I could even go pick up one in person if I wanted to. Very nice people there! Sent from my...
  9. BPopilek

    Did the Denali ever come with heated wind shield wiper fluid?

    So I stumbled across this thread tonight and just had to go look at my 2008 Yukon SLT. Sure enough, the recall has been done to my truck long before I bought it. The unit and fuse are both gone. However, I still have the button and mounting bracket installed. I was reading up on the AT-380D...
  10. BPopilek

    2008 Yukon with LQ4 Engine Mod Questions

    So I am in the process of building an LQ4 6.0l block, out of my friend's 2000 Silverado 2500, for my truck. I have a couple questions that I am looking for some guidance on. Since the truck it is going into is a 2008, I know that some of the sensors are completely different or found in...
  11. BPopilek

    Tuning Advice Needed

    One last question for you Justin. If I were to get the V2 or AutoCal, are they locked to a single VIN, or can they be used on other vehicles I own as well? Thanks!
  12. BPopilek

    Tuning Advice Needed

    For your $250 price, is that also unlimited tunes using an HP Tuner? Or is it for a set amount? Sent from my iPhone using Tapatalk Pro
  13. BPopilek

    Tuning Advice Needed

    Ok very cool. I will definitely keep this in mind when I get to that point. As of right now, it's probably going to be a month or two before I am ready to install it. How long does it take for the programming equipment to arrive after it is ordered? I get 6 days off from work every other week...
  14. BPopilek

    Tuning Advice Needed

    Either option sounds like it would probably work. I don't necessarily need the ability to make the changes myself if there are unlimited tunes. I am interested in the cost of each option and the turn around time to get the flash files.
  15. BPopilek

    Tuning Advice Needed

    Yes I already have a new reluctor ring on hand that will be installed on the crank. As far as tuning goes, I need something intially to get it running and driving after the engine is installed. Then probably tuned up after driving it around for a bit. I do plan to add a turbo to it later on, so...
See more

Forum statistics

Threads
138,110
Posts
1,999,297
Members
103,037
Latest member
Durobans

Latest posts

Back
Top