Recent content by alaska_guy

  1. alaska_guy

    Programming mileage in a replacement cluster

    I'm in Palmer, AK.
  2. alaska_guy

    Heated seat thermistor bypass?

    The junkyard in Chugiak let's you do u pull its. I did it all the time.
  3. alaska_guy

    Update to adding trans temp gauge...

    Hp tuners will allow you to fix the axle ratio and brake booster message. If I had my suburban still I would of been able to tell you what two wires to tie together to get rid of that message. It's looking for a normally closed circuit.
  4. alaska_guy

    2004 Yukon Dash Light Issue

    Cluster needs to be rebuilt if your not getting odometer, PRNDL. Etc. Not sure on your radio. The circuit controlling those is your accessory switched 12v wire.
  5. alaska_guy

    Programming mileage in a replacement cluster

    Multiple ways to do it... to bad your too far away. I only charge $40 to reprogram mileage.
  6. alaska_guy

    Key and Key Fob Replacement Guide

    Does this same procedure work on 03-06?? I would like another fob
  7. alaska_guy

    Tool to disable tpms all together

    It's not the light. It's the one that says "service tires" or whatever on the odometer display
  8. alaska_guy

    Tool to disable tpms all together

    I took the escalade to a few shops a few years ago, had new sensors put in, had them try and pair etc etc. Both shops said well sometimes they just don't pair properly and it's something with your vehicle. Long story short, what tool can I buy to delete the tpms message on the cluster.
  9. alaska_guy

    Update to adding trans temp gauge...

    You can remove the brake booster message by shorting the two outer pins on the connector. I did this on my suburban.
  10. alaska_guy

    Wife's escalade taking a while for heat.

    I back flushed the heater core as I said I was going to do. That fixed the issue.
  11. alaska_guy

    Wife's escalade taking a while for heat.

    Working nice and hot now.
  12. alaska_guy

    Wife's escalade taking a while for heat.

    Ok, not the thermostat. Another issue I haven't spent time to fix. Obd port no longer works. Crawled under and no wires disconnected grounded etc I could see. So I can't scan with my reader. Common issue for blend motor? I know of Silverado there is some resistor pack deal on the passenger...
  13. alaska_guy

    2006 gmc yukon xl slt plus gauge cluster.

    Yeah, more than likely he just doesn't like programming them. I rebuild clusters locally and easiest way is to buy new eproms, flash them with trans motor settings and then place the new chip on your cluster. At least that's how I do it. It's not hard, but takes time. Where about are you...
  14. alaska_guy

    Wife's escalade taking a while for heat.

    Vehicle only has 130k moles on it. We are the second owner purchased with 98k miles. Had the entire thing gone through by the dealer when we bought it and have had numerous spot checks along the way as we get the oil changed. Radiator looks fine. I will replace the tstat as that's an easy...
  15. alaska_guy

    Wife's escalade taking a while for heat.

    Coolant level is fine. I had the blend motors fixed initially when I bought the vehicle as it would only blow cool air in the rear. The heat eventually works, scan tool and gauges match for coolant temp. I have a laptop to datalog real time. So replace thermostat first and then look at blend...
See more

Forum statistics

Threads
129,196
Posts
1,811,980
Members
92,297
Latest member
btheboyscout

Latest posts

Top