-
-
EddieC replied to the thread what's everyone do for work? new here - from eastern eastern nc!."It's not my job to run the train, the whistle I can't blow, But let the damn thing jump the track, and see who catches hell!" -
EddieC replied to the thread A/C Question.Thanks for that information. Unfortunately that gives me the impression that the average shop is not going to know how to repair the...
-
That's basically correct, but our systems have two pressure switches: a low-pressure switch and a high-pressure switch. If you have far...
-
EddieC replied to the thread A/C Question.If not already mentioned, I found that when my refrigerant was low the system would not engage, not even a little; the light on the...
-
EddieC replied to the thread A/C Question.This is from left field and may have no bearing but Subaru's ac clutch has a specified gap range between the engaging face plate and the...
-
EddieC replied to the thread Front CV-Axle Replacement Question.The hub had previously been changed so the axle was fairly easy to get moving in the hub. The issue was the clearances, first to get...
-
EddieC replied to the thread Front CV-Axle Replacement Question.I wish min went that easily. Perhaps the passenger's side will.
-
EddieC replied to the thread Front CV-Axle Replacement Question.I had to remove the sway bar link, the tie rod end connection to the steering knuckle to get the strut to even wiggle. At that point...
-
EddieC replied to the thread Brake Caliper Slide Pin Question.I only measured .005" difference in diameter from the originals and new aftermarket replacements. There was not much difference in the feel.
-
Pretty sure that's normal. If you put grease in, there's no obvious wear, and they don't bind or clunk, I'm pretty sure it's...
-
EddieC replied to the thread Brake Caliper Slide Pin Question.What I wrote was "Regarding rear brakes, when the caliper is removed, should there be any noticeable wobble of the individual (loose)...
-
EddieC replied to the thread Brake Caliper Slide Pin Question.Thank but not the question. Should the pins have noticible wiggle room in the bracket holes?
-
Regarding rear brakes, when the caliper is removed, should there be any noticeable wobble of the individual (loose) pins in the bracket...
-
EddieC replied to the thread Wow at the Pump.Luckily we only adopt CA standards and not the pricing. Emissions is one thing but seismic requirements was always obsessive to me. Glad...
-
EddieC replied to the thread Wow at the Pump.I was surprised to see it being we seem to follow California standards. There were no restriction on the pump other than the price. For...
-
-
Loading…
-
Loading…
