-
-
Llspann3525 replied to the thread Bought core block.yes they make a conversation harness but this engine going into an old school g body.
-
Llspann3525 replied to the thread Bought core block.update: my gen 3 build is almost done. Pretty much replaced everything inside. New timing chain, seals, rings and all. I went with...
-
-
Llspann3525 reacted to donjetman's post in the thread GM Oil Consumption TSB/Technical Service Bulletin Link with
Like.
The oil consumption GM Technical Service Bulletin Link that I have provided and posted here at TYE forums for 6+ yrs is dead. Here is a... -
Llspann3525 replied to the thread Oil pressure issue.Also did you change the lifter valley oil filter underneath the oil pressure sensor if it gets dirty or clogged it will cause low oil...
-
Llspann3525 replied to the thread Steering Rack Replacement.Nevermind 35 ft lbs for rack to steering shaft bolt
-
Llspann3525 replied to the thread Steering Rack Replacement.by chance know the torque spec for steering shaft to rack bolt i will be using blue loctite
-
Llspann3525 replied to the thread Steering Rack Replacement.Im going to install mine this weekend. I paid 30 bucks for the power steering cup seals from autozone and they had to be shipped to my...
-
Llspann3525 replied to the thread Steering Rack Replacement.Today I was prepping to do the rack and pinion and couldnt locate the cup seals locally. I ended up ordering them from autozone. My...
-
L@lspann3525 I just looped the seatbelt through the bottom rung of the steering wheel, that part wasn't a big deal
-
Llspann3525 replied to the thread Steering Rack Replacement.I went with the detriot axle rack and pinion it came with new outer tie rods but no o-rings or jam nut...How are yall securing the...
-
Llspann3525 replied to the thread Steering Rack Replacement.I am about to try to tackle the same job. Can replacement tie rod jam nuts be purchased locally?? I was wanting to pull my rack with the...
-
Llspann3525 replied to the thread 2012 Yukon/Possible sign of bad head gasket? - SOLVED.head gasket will cause the oil to look similar to a milk-shake. Disappearing coolant could be heater core but you will usually smell it
-
-
Loading…
-
Loading…
