What did you do to your OBS GMT400 Tahoe/Yukon Today?
- Thread starter 96ProCompTahoe
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
SunlitComet
OBS Jedi-Do Good
kept having to relax my foot on the gas becuase i would get a neck snap or suddenly realize i was doing 80+ in an outboard lane. thought i would have had it done by now.
---------- Post added at 07:58 PM ---------- Previous post was at 07:56 PM ----------
any body know of a completely aluminum grille? not that insert crap either.
---------- Post added at 07:58 PM ---------- Previous post was at 07:56 PM ----------
any body know of a completely aluminum grille? not that insert crap either.
SunlitComet
OBS Jedi-Do Good
who? little old me?
---------- Post added at 08:59 PM ---------- Previous post was at 08:51 PM ----------
stock outlet of body is supposed to be 70mm but the opening in plenum is 75mm i think. do not get one bored out more then 75mm. it will either bind(thottle) or you will get disturbed airflow as it hits the plenum or you will need and adpter to prevent binding and it usually just knocks the bore back down again before entering plenum.
---------- Post added at 08:59 PM ---------- Previous post was at 08:51 PM ----------
stock outlet of body is supposed to be 70mm but the opening in plenum is 75mm i think. do not get one bored out more then 75mm. it will either bind(thottle) or you will get disturbed airflow as it hits the plenum or you will need and adpter to prevent binding and it usually just knocks the bore back down again before entering plenum.
Phantom240
Full Access Member
- Joined
- Sep 28, 2012
- Posts
- 144
- Reaction score
- 1
Got my new bluetooth OBD2 scanner today. Hooked it up after I got home, and noted stored codes. Deleted old codes, did a couple trips here and there, and when the SES light came on, pulled the codes. Only two remain: The EGR code (likely stuck open, and I have another waiting to get installed), and the Cam Sensor code. Gonna make sure all my wiring is good before I replace that.
The program on my phone to sync with the OBD scanner is friggin sweet.
The program on my phone to sync with the OBD scanner is friggin sweet.
slipping
Full Access Member
Woke up stoopid early to drive it down to Pomona swap meet.
VicYukon
Member
I was up way too early so I painted my differential cover red looks pretty kool.
SunlitComet
OBS Jedi-Do Good
please fix signature. and uh, a vortec engine with a jet performance chip?
swapped in my NBS master cylinder.
AWESOME!!!!! I recommend this to everyone with the squishy OBS brake pedal.
My pedal is now very firm.
You need an AGS BLF-26C brake line adapter from AutoZone and obviously a NBS 1500 series master cylinder.
bleed the master cylinder against a tire stop
AWESOME!!!!! I recommend this to everyone with the squishy OBS brake pedal.
My pedal is now very firm.
You need an AGS BLF-26C brake line adapter from AutoZone and obviously a NBS 1500 series master cylinder.
bleed the master cylinder against a tire stop
Gzes
the drifting 2dr
Too bad my hoe has a new one or i would do the swap
