How to turn ignition w/out engine on 21 RST?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

West1

Member
Joined
Dec 26, 2020
Posts
30
Reaction score
6
I’m feeling a little stupid rn as I can’t figure out how to turn the ignition on so the code reader can scan. I put the accessories on and ran the scanner but it doesn’t feel right w/out the dash lighting up.

The past 2 days I’ve received a Low Oil notification but I’m at 35% oil life left, has me a little worried.

I purchased new synthetic 0-20 (currently 34k miles) to replace my oil as I’m headed to a big driving trip for Christmas (hopefully!).

I’m hoping the ecm recorded something so I can see if it’s a sensor, o-ring, fuel pump etc so I can fix prior to our trip.

Thanks for the help!
 
OP
OP
W

West1

Member
Joined
Dec 26, 2020
Posts
30
Reaction score
6
Without your foot on the brake, press and hold the start/stop button for ~5 seconds. You'll see all the tell-tale lights on the cluster come on for pre-drive check and now your ignition is on w/o engine running.
Thank you!!
 

olyelr

Full Access Member
Joined
Mar 19, 2011
Posts
1,645
Reaction score
776
Location
Elk Rapids, MI
I’m feeling a little stupid rn as I can’t figure out how to turn the ignition on so the code reader can scan. I put the accessories on and ran the scanner but it doesn’t feel right w/out the dash lighting up.

The past 2 days I’ve received a Low Oil notification but I’m at 35% oil life left, has me a little worried.

I purchased new synthetic 0-20 (currently 34k miles) to replace my oil as I’m headed to a big driving trip for Christmas (hopefully!).

I’m hoping the ecm recorded something so I can see if it’s a sensor, o-ring, fuel pump etc so I can fix prior to our trip.

Thanks for the help!
Well, did you check the oil level?
 
OP
OP
W

West1

Member
Joined
Dec 26, 2020
Posts
30
Reaction score
6
Well, did you check the oil level?
I did and it was low. Not sure why it was low, no signs of oil leaks either.

I did an oil change and now checking spark plugs to see if there’s oil in there.
So far, engine seems fine and not burning anything. I’ll take it tomorrow for a compression test. I usually do my own oil changes and I got lazy in the last one and went to a drive thru oil change. They must of under filled the oil.
 

olyelr

Full Access Member
Joined
Mar 19, 2011
Posts
1,645
Reaction score
776
Location
Elk Rapids, MI
I did and it was low. Not sure why it was low, no signs of oil leaks either.

I did an oil change and now checking spark plugs to see if there’s oil in there.
So far, engine seems fine and not burning anything. I’ll take it tomorrow for a compression test. I usually do my own oil changes and I got lazy in the last one and went to a drive thru oil change. They must of under filled the oil.
Its very possible.

I would just change the oil and monitor the level through this next run.
 
OP
OP
W

West1

Member
Joined
Dec 26, 2020
Posts
30
Reaction score
6
No oil in 2 spark plugs, one on each side.
Went for a 20min drive and oil pressure seems normal. 28ish psi - 60psi from idle to 55mph.

Can’t blame the oil change place to much as I should have checked my oil monthly at min. Lesson learned
 

olyelr

Full Access Member
Joined
Mar 19, 2011
Posts
1,645
Reaction score
776
Location
Elk Rapids, MI
It seems like a little low on oil at next service is somewhat normal with these motors. I have not heard of it being so low that the low oil engine light came on though.
 

Forum statistics

Threads
129,251
Posts
1,812,849
Members
92,354
Latest member
Off Road Pedia
Top