All is good. as soon as I re-seated the oil pick-up tube the pressure settled nicely at 60. The flywheel bolt was the culprit on the noise it seems; as the very loud clicking noise is gone. I'll tell you the @#$% you have to go through to get the oil pan off is ridiculous! terrible engineering.
In order to see the bottom of the engine components and if anything had dropped down into the pan it was necessary to remove a baffle and the pick up tube. Once I could see up into the block I slowly turned the fly wheel to get the engine components to slightly move as to inspect them. It was...
Thanks - I just went through that thread - have a hard time thinking the sender went coincidentally! Am hoping someone else had the issue and could tell me - "it is the torque of the pick-up tube" or "the pressure needs to build - let it run, I don't dare let it go for more than a few minutes...
Hey all - New to this forum. I have a 2000 Tahoe LS with the 5.3. Needed to get into oil pan - terrible clicking in the back of the oil pan. Winds up a flywheel to drive plate bolt worket it its way loose. I get that torqued upped. Now after replacing the gasket and getting it all tightened up I...
For the last few years I have had a very small oil leak at the pan where the front cooling lines would enter the pan (driver-side rear of pan) if equiped. I finally decided to pull the pan off and replace the gasket, "o-rings in the pick up tube, and general sludge removal. I have the pan...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.