Yes I have 4-5 different ones and all various lengths by manufactures. The best thing to do is disconnect front u joint and push driveshaft all the way into transfer case then measure how long of shaft u need to u joint centerline from front diff to rear I joint at case. Get that measurement and...
I put an Escalade third brake light on my yukon and took this one off. Everything works and only a couple faint scratches. I haven’t tried wet sand and polish but very possible to come out. $40 plus shipping
Mine has the same left side front end pop. I checked all connections and everything looks good. I’m guessing it’s an upper or lower control arm bushing at frame. Maybe the rack itself but not sure. Happens when I first drive it after sitting a while and only when turning right.
Those are just z71 flares on a lt. the ltz and denali have different rear bumpers. The hole mounts are slightly different too. Takes a little finesse to fit on a yukon but it does work
They will fit your denali with the mods I pictured. You will need to cut and shave the front edge to bumper along with rear body to bumper line. The denali has a different rear bumper that leaves a tiny gap on the lower section of flare. That’s what I was referring for about make sure you mold...
Rough country lift doesn’t have any rear drop members for suspension. I prefer pro comp 6” over it or bds/zone 4”. All of those increase front track width. Bulletproof 6-8” doesn’t increase width. Might need rear pro comp drop brackets can’t be certain right now for bulletproof.
Wheel choice...
Your model most likely has the magnetic and air ride. Easiest way to tell is look for the ride height sensors. Either kit will work but suspension max comes with the brackets. Maybe ccm makes them now but not positive.
@Blkdout07
Thanks man! Definitely tried to share the knowledge of dealing with a lift on auto ride. The 10-24 rod does work just loses the infinite adjustments of rod spacers. Must of gone up on costs because they were $40 a pair. Sounds like you figured out the front splice you retain electric...
I’ve used power stop and like the stop tech better so far. Used them on 3 cars now. Thanks man! I try to keep it clean and nice. Eventually I’ll get some coil overs and ditch the auto ride system. Not sure when maybe another year
No problem. Yes with their rotors. First time with these pads but rotors have been great so figure pads could be good too. Definitely notice better pedal response already
Looks good. You could of went with the 305/45R22 versions which are XL rated and only weigh 47 lbs compared to yours at 63 lbs. Also load rating is 118 to 124.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.