Finally got it! I went to Advance Auto one more time and found a 1/2" brass plug. The threads lined up perfectly and I even confirmed with caliper.
I brought them back, put some thread sealant on them, topped off fluids, tightened with 7/8 SAE socket, and torqued to 35 ft lbs (not sure if that...
The plot thickens. Got these ordered a week ago, and picked up from the dealer today, only to notice that they were about a third the size that they need to be. Before ordering, the GM parts department confirmed that that was the right part for my transfer case, so based on what the numbers say...
Thanks for posting, this was super helpful! I stopped by my local Chevy dealer and they special order them. The part number they had matched the one you sent.
I recently changed the fluids in the transfer case and noticed that the plugs are pretty mangled, and I don't want to risk stripping them next time. I ordered these two from Amazon to replace the fill and drain plugs but even though they should fit according to Amazon and Rock Auto, they aren't...
Apologies in advance for yet another AFM/DOD post to muddy the forum waters, but I have the 6.2L with 180k. It has a collapsed lifter and low oil pressure (leaking from oil pump). It may be conjecture for me to assume that it is AFM related, but I do hear that this type of problem is a common...
This is a 2012 Yukon XL Denali that has had a few previous owners, and with that, dings amd scratches. Those don't bother me at all from a cosmetic level, but what does bother me is the potential of rusting. There are a couple of areas that I can see where the paint has chipped off, and I can...
Has anyone used the XTool D7 for key programming on Yukons? I have a 2012 Yukon XL Denali that I am trying trying to program a key for. This is one of the years after the switch to no longer be able to do it natively in the truck. I was able to program the remote (with buttons), but I cannot...
Hello,
I am trying to tap this portable head unit with integrated dash cam into my fuse box so as to not drain power from the battery when the truck is off. The issue is, when I hooked up the multimeter to the fuse box on the driver's side, I couldn't find a good fuse to tap into safely. I was...
I have always been curious about these small vxdiag type tools that connect to a laptop versus an xtool, autel, launch ~$500 tool. Have you compared it to any of those?
Hey everyone, I went through and checked connections and did notice that the negative terminal cable was a little loose. Not extremely loose, but loose enough to justify tightening. After doing that, I haven't noticed the issue. I'll let you all know if anything changes. Thanks for all the help!
Twice today I had the same issue where I try to start er up, only to be met with dead silence. No power. No lights. No cranking. After this happens, there are electrical popping noises happening throughout the cabin. The first time, I walked outside to check under the hood (didn't change...
I have heard a lot of good things about the maestro adapter, but as far as the other adapters, do you remember what all you needed? Do you remember which head unit you ended up getting?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.