Thank you for the information. Update: I was able to get it open again, and figured out how to remove the plastic storage compartment to easily open again with a screwdriver if it locks. It seems to intermittently work now from the electronic button up front and the outside of the liftgate...
So it is closed again and not opening again. It was an act of God to use an allen wrench to get that latch open, great difficulty do it again. This large piece of plastic molding is right in the way of getting a direct screwdriver shot to that latch. Any idea how to remove it? I see no way to...
And now that I have gotten it open, we shut it fully using the front cabin button, and it close like normal. And then it opened like normal with the front button. Appears to be operating normally now. Something definitely happened and I’m not sure what it was. Does it sound like the latch has...
OK, I finally got it open. When it’s open fully, it stays open. When I push the liftgate button on the door, it starts to close like normal and the back lights flash.
Thank you for the information. I don’t know, I cannot get it open. I did read about the dimple in the plastic and drilling a hole and so forth. The problem is somebody put some type of aftermarket or maybe even a GMC plastic thing in the back and it sticks up about 4 inches so you can’t get...
Our liftgate has stopped working completely. When you press the rear button manually, the back lights flash but nothing happens. The front ceiling switch is on but does nothing, nor does the remote. I started basic troubleshooting by checking fuses and relay. Here is a photo of the rear...
Update: thank you for this great information. I did replace the sensor again and thermostat and topped off sith Dexcool. I used AC Delco parts (did not see your post before I did it. So far so good, temp gauge reads right in middle now, so I believe it to be fixed. I should have replaced...
Maybe. The fan I refer to is the radiator fan that keeps running after the vehicle is shut off. It seems to think it is overheated, which is why I replaced the sensor.
Thank you so much for the input. I checked the wiring for the sensor before replacing it but will again. You gave me some good things to consider. The very sporadic nature of it is strange to me.
Hello, I am new here and hoping to maybe get some direction on a problem we are having with our 2016 Yukon Denali. Over the past several months the engine fan will start running at high speed and continued even after the engine is completely shut off for several minutes. It only happened about...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.