Recent content by iseckora
-
Wheel well liner
Hello all- I've had a 3 inch body lift done to my 2013 tahoe 4wd. Are there any metal wheel well liners on the market? Or should I stay with stock and gap liners? Or is it possible to take a sheet of 3mm rubber heat it up and form it over the stock wheel well liners to get a shape and have one... -
2013 Tahoe/Towing question
Do you have a link or a can I goto a mechanic and ask then to install this?- iseckora
- Post #6
- Forum: Engine & Drivetrain
-
2013 Tahoe/Towing question
Afternoon all!! I have a 2013 Tahoe with a 3.5 inch rough country lift, and a 3 inch body lift, riding on 33s. My question is I am a travel contract worker and my gf is as well. We are looking at taking a contract in Alaska for a bit and we want to take her 2016 Jeep Wrangler 4d. Is my tahoe...- iseckora
- Thread
- Replies: 34
- Forum: Engine & Drivetrain
-
Cutting plastic for tires rubbing
It rubs the fender a little bit not much... -
Introduction
I don't have a garage but when we rolled her outta my buddies garage it was tight- iseckora
- Post #8
- Forum: Introduction
-
Cutting plastic for tires rubbing
This is the area that is rubbing when I turn a tight turn -
-
Cutting plastic for tires rubbing
I'll upload pics tomorrow when I can take some shots with light. Thanks for the information thus far. -
Cutting plastic for tires rubbing
My new 33inch tires are rubbing the inner plastic when I do a tight turn. Anyone have advice on cutting the plastic to allow room for the turn? Or a schematic of what's behind the plastic that I can cut apart? I don't need a huge amount of room but definitely need to do. Thanks!!! -
Introduction
Hey All- I'm Isaac living in Billings, MT. I have a 2013 Chevy Tahoe. Just lifted her with a 3.5 inch lift from Rough Country and running 33s with Anthem rims from Custom Offsets. Front bumper is from Iron Bull Bumpers and have a matching rear bumper in the works from them. Plan is to finsh...- iseckora
- Thread
- Replies: 9
- Forum: Introduction
