Recent content by GMCYukon2009

  1. GMCYukon2009

    Evap issue question 09 yukon 5.3? - SOLVED

    I found some carbon pellets inside the canister purge valve on the engine so I had a shop replace the carbon vapor canister and blow out the lines. It works perfectly now. Once again thanks for the replies.
  2. GMCYukon2009

    Evap issue question 09 yukon 5.3? - SOLVED

    Thanks for the replies.
  3. GMCYukon2009

    Evap issue question 09 yukon 5.3? - SOLVED

    I've replaced the canister vent valve solenoid ( by rear end) and the canister purge valve ( on engine ). I still cannot fill fuel without the gas nozzle clicking off often. I can fill slowly. Can I run the vehicle or will something else go wrong before I can get it fixed? Thanks
  4. GMCYukon2009

    Replaced exterior door handles

    The original handles were painted and peeling badly. I think these turned out well. When installing I had a little issue with the first rear door. I was finishing up and tried the door to make sure everything worked properly. I soon as I shut the door I knew I had a problem, the door rattled. I...
  5. GMCYukon2009

    Air Bag recall

    Thanks for the response. I tried looking up there but I may need my wife's smaller frame to get e better angle. I only saw a couple bolt heads and no missing bolt holes.
  6. GMCYukon2009

    Air Bag recall

    Had mine replaced today. Dash is already cracked and they gave me the warning " we might make it worse ". It took less than 30 minutes. I placed my ins. card and reg. back in the glove box before leaving and a screw fell our from above in the glove box. I asked them what it was for and they...
  7. GMCYukon2009

    Removed Door Moldings

    The image on the left can be seen better. It looks like a bright/clean spot in the driveway but it's discoloration on the door panel. Facing the other way it's harder to see. Sorry for the late response.
  8. GMCYukon2009

    Removed Door Moldings

    Thanks for the replies. I ended up using acetone which I was hesitant using. It worked well for removing the glue remnants. I washed the area afterwards and reapplied wax and it looks great. There's still a faint color mismatch on the left front that my wife says I'm the only one that will...
  9. GMCYukon2009

    Removed Door Moldings

    I removed the door moldings and now have faint discoloration where the tape used to be. What's the best way to clean/wax/ areas to remove any residue from where the moldings used to be? Thanks
See more

Forum statistics

Threads
134,746
Posts
1,907,447
Members
100,136
Latest member
Malakas

Latest posts

Top