Recent content by George Owens

  1. George Owens

    Suspension issue? 08 Tahoe 204k

    I’ve seen a few videos where they also mentioned the intermediate shaft as well
  2. George Owens

    Suspension issue? 08 Tahoe 204k

    So I have a question and this has been going on for a while. I have a 08 Tahoe four-wheel-drive 204k miles on it. From time to time I hear a clunking noise while turning slow sometimes even backing up. But what I can’t figure out is that both of my CV axles have been replaced and is fairly new...
  3. George Owens

    Charcoal canister hose

    08 Tahoe
  4. George Owens

    Charcoal canister hose

    So I was getting ready to replace the charcoal canister when I noticed there wasn’t a hose connected to the one that was already in the car so I looked around and found this hose cracked on one side, and not connected to the other. Do anybody know the part number for this or at least could put...
  5. George Owens

    Intermittent issue Bcm/ecm

    Just an update the last time this issue acted up was around march 9th and has not since acted up once I unplugged fuel control module connected and reconnected it, I guess it was slightly out of place maybe that’s why it acted up on hard bumps and intermittently. I’ll say this case had been...
  6. George Owens

    Issues with P0455

    Would a smoke test reveal the issue?
  7. George Owens

    Intermittent issue Bcm/ecm

    Here’s an update: it’s been about 2 maybe three weeks and I’ve had no issues I did order the fuel pump control module and it’s still sitting in the box but what I did was take off the connector put some grease on it and put it back. It didn’t look loose, but maybe it was loose enough to cause...
  8. George Owens

    Intermittent issue Bcm/ecm

    So this morning while I am dropping my son off at school, we were waiting for the door to open so I cut the car off but left it in the on position so that means it was no vibration to make anything become loose or anything of the sort. So it happened again And wiggling wires didn’t seem to work...
  9. George Owens

    I suspect BCM... thoughts?

    Could anyone point me in the direction of a wiring chart for the can bus by any chance?
  10. George Owens

    Intermittent issue Bcm/ecm

    I should double back and check wires around this area because this is the second time, it seems like heavy bass seem to activate the problem, and once I wiggled wires/slap the box, it went away
  11. George Owens

    Intermittent issue Bcm/ecm

    Welp was fine since last Saturday acted up for a second then went back to normal right around the corner from my house soooopo frustrating I had high hopes for this
  12. George Owens

    Intermittent issue Bcm/ecm

    You know how to open this bad boy up?
  13. George Owens

    Intermittent issue Bcm/ecm

    Welp I just switched it out now we wait
  14. George Owens

    Intermittent issue Bcm/ecm

    I wouldn’t know what to do solder wise I did order one that might not get to me till Tuesday, it acted up again today on the way to work was fortunate to make it and it went back to normal. I watched this video which also makes me suspect the junction box more so watch it from the middle to the...
  15. George Owens

    Intermittent issue Bcm/ecm

    So it’s possible for that to act up intermittently?
See more

Forum statistics

Threads
137,717
Posts
1,990,312
Members
102,709
Latest member
SuburbanPassion95

Latest posts

Back
Top