-
-
Ccoz3z3 replied to the thread What Would You Do?.Not a bad idea, but I'm trying to not have to replace motor AND trans. Just motor. But worse comes to worse, good to have that idea
-
Ccoz3z3 replied to the thread What Would You Do?.Trying to keep it as straight as possible. Hard with having to get over the motor mounts on the frame. Will try to remove them from the...
-
Ccoz3z3 replied to the thread What Would You Do?.Anything special to pulling it from the tranny or is just like anything else? Yanked and yanked and yanked on it for quite some time...
-
Ccoz3z3 replied to the thread What Would You Do?.Hey everyone! Project is still underway and still looking for a motor. Thanks for everyone's suggestions. At this time, it's been put on...
-
Ccoz3z3 replied to the thread What Would You Do?.Interesting! Thank you. Yes, I have found a few that were a couple hundred dollars less than the L94. I thought it to be a little funny...
-
Ccoz3z3 replied to the thread What Would You Do?.This was my third option I was looking at. A gen 4 6.0. My second option was looking at a L92 and then just tuning out DOD. For some...
-
Ccoz3z3 replied to the thread What Would You Do?.Sell it as is right now? Or do you mean like take the motor and send it on its way? My initial investment is almost nothing. I paid...
-
Ccoz3z3 replied to the thread What Would You Do?.I've thought about this as well. I wasn't sure how much this would devalue the vehicle. Although I can find them cheaper, I'd then need...
-
Ccoz3z3 replied to the thread What Would You Do?.Sweet thanks for the reply. I'm not too concerned with the budget right now. Because at first, when I wanted to keep it, I went straight...
-
CHello! New here and wanted to get some opinions on what I should do. Back in November, I acquired a 2013 Yukon XL Denali in great...
-
-
Loading…
-
Loading…
