Charlie207
Full Access Member From LFOD, New Hampshire
- Joined
- Last seen
- Viewing thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?
Latest activity Postings About
-
-
Charlie207 reacted to Geotrash's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Like.
Both shocks look good with no leaks and have been performing well, so I'm just going to replace the control arms and outer tie rod ends... -
Are there better alignment specs, vs. OEM specs., for vehicles with (small) lifts? I'm running the Bilstein 5100s on the highest...
-
Charlie207 reacted to Jdsfx1's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Faux
-
Charlie207 replied to the thread Fuel pump question.Rock Auto is certainly showing different part numbers for 2007 vs. 2008 vs. 2014, as examples.
-
Charlie207 replied to the thread 2010 Yukon 6.2L DIY DOD Delete / Engine Rebuild - Starter issue - RESOLVED.Should be enough though, right?
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Neat! Are those faux or real beadlocks?
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.So you're keeping it 4wd? is it going to be lifted?
-
Charlie207 reacted to alpha_omega's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Been keeping busy. Frame is painted and re “waxed” with cosmoline. Time for assembly.
-
Charlie207 reacted to Jdsfx1's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
I was going to use a GMC Envoy but I thought the Yukon was just a better base. It will be a little more difficult due to the width of...
-
Charlie207 replied to the thread Headlight housing interchangeable????.Yukon headlights look to be wider. I imagine if they were directly swappable then we would have seen a lot of that happening already.
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.What made you go with the GMT900 platform?
-
Charlie207 reacted to Jdsfx1's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Cut my Yukon XL in half and removed 12” from the frame, then welded it back together and added fishplates for additional strength. Now...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.That's bold! Why?
-
Charlie207 replied to the thread Useless Information.This reminds me.... sometime in the past, someone with a mild lift shared some targeted alignment specs to provide the shop. I recently...
-
Charlie207 replied to the thread SOLVED: Bolt extractor head broke off - advice needed.You just reuse that ground bolt in place of one of the Dorman bolts. There is a separate clamp that works for the drive's...
-
-
Loading…
-
Loading…
