Recent content by cameradude
-
How do I clean up and restore the finish on my running boards ?
Solution Finish is the way to go....will last about 6mo with typical use and washing. It's not slippery. If you want a more permanent finish try Cerakote Trim Coat...they've got some automotive finishes for plastic trim. A registered professional detailer in your area should be able to help you...- cameradude
- Post #12
- Forum: Exterior
-
Valve cover gasket write up?
"8) Apply a small amount of fresh oil or axle/bearing grease to the inner hole of the new grommet and push the screw/tube through it. This will be the toughest part of the whole process. I got an 8mm (or 6 or 7?) deep wall 1/4" drive socket- whatever size it was that matched the diameter of...- cameradude
- Post #21
- Forum: Engine & Drivetrain
-
Another headlight retro
...been reading that. Some of the guys have advised just modding the oem light but I've already purchased and installed the lights. Guess I'll have to think about it. Gonna do some more reading on this as I've been given a few links on people that have done retros on my particular vehicle.- cameradude
- Post #24
- Forum: Exterior
-
Another headlight retro
need more specifics... Just bought a pair of 07 Tahoe Spyder replacement headlights w/ ccfl halos and am looking to swap out the halogen projectors to hids. What brand and model should I look for to run DS2 bulbs that will be a drop in fit to the Spyder housing? Also will I have to shave down...- cameradude
- Post #22
- Forum: Exterior
