Recent content by BPiatchek
-
B
Ignition 1 Signal 0 volts Engine turns over but wont start! - SOLVED
Solved! Thanks so much for everyone’s help on this! Ended up being a bad relay. Specfically, it was the “EDU” #5 relay… So happy to have this resolved!- BPiatchek
- Post #13
- Forum: General Discussion
-
B
Ignition 1 Signal 0 volts Engine turns over but wont start! - SOLVED
I purchase a USED OEM ( Tested good ) Ignition switch w/ assembly from Ebay. I came with a new key as well...- BPiatchek
- Post #11
- Forum: General Discussion
-
B
Ignition 1 Signal 0 volts Engine turns over but wont start! - SOLVED
Fless - That's awesome! All good information. I am going to dig into those fuse panels when I get home this afternoon. Although I have visually checked all of those fuses, I haven't checked all of them with my meter. So that would be good to do. I have had fuses that looked good and tested bad...- BPiatchek
- Post #10
- Forum: General Discussion
-
B
Ignition 1 Signal 0 volts Engine turns over but wont start! - SOLVED
Donal, I changed out the "ignition switch w/ assembly" I had to replace the ignition switch because it had become rusted \ corroded on the inside. I had problems with the PASSLOCK ever since. I kept having to do that process where you leave the key in the ON position for 10 min intervals...- BPiatchek
- Post #7
- Forum: General Discussion
-
B
Ignition 1 Signal 0 volts Engine turns over but wont start! - SOLVED
Scottydoggs, My tach needle barely moves, but it moves when cranking. So, I hooked up my scanner to watch the live engine data "engine speed" RPM - When the engine begins to turn over RPM reading jumps from 0 to about 155. I don't know if it's normal, but after the engine stops turning over and...- BPiatchek
- Post #5
- Forum: General Discussion
-
B
Ignition 1 Signal 0 volts Engine turns over but wont start! - SOLVED
I have a 2004 Chevy Tahoe. I’ve been having problems off and on with it not starting. Engine will turn over, but will not start. Well, its gone from intermittent to now it wont start period. I attributed this to a PASSLOCK issue since my code scanner was showing VTD Fuel Disable Active. I had...- BPiatchek
- Thread
- 2004 tahoe 2006 tahoe ignition ignition signal schmatics will not start
- Replies: 14
- Forum: General Discussion
-
B
Help with Diagnostic Software. What to us on 04 Tahoe? PASSLOCK Problems
Hey guys, thanks for the responses.. Yes, I have tried the usual, typical measures. Tired several times disconnecting the battery... both Neg and Pos. My bad, I did intend to say 10 mins on, 30 sec off. Actually, the instructions I read said 11 mins, but they also said " when the security light... -
B
Help with Diagnostic Software. What to us on 04 Tahoe? PASSLOCK Problems
Thank you. i had considered doing that. I did see this company. You send then your VIN and they program it to match. Do you believe this what I need to do or should I go another direction? What about the diagnosis software? I’ve already bought it so I need to make use of it.. Do you know what... -
B
Help with Diagnostic Software. What to us on 04 Tahoe? PASSLOCK Problems
Hey guys, I have recently purchased the VXDIAG VCX NANO for GM / OPEL Diagnostic Tool on amazon. I was hoping to use this communications adaptor to run Tech2Win software using a VM with Windows 7 32-bit OS. My problem is, I don't know what version I need for 2004 Tahoe or is that software would... -
B
Swapping Yukon XL Captain chairs with Seat Rails from 03 Escalade. Trying to fit in 05 Tahoe.
So the answer is that it can be done, but I had to buy a second set of captain chairs in bad condition out of a 03 Escalade and interchange some pieces. I used the seat brackets from the escalade as well as the upper seat frames. I had to remove the seat covers from the top seat frame of the... -
B
Swapping Yukon XL Captain chairs with Seat Rails from 03 Escalade. Trying to fit in 05 Tahoe.
As far as the seatbelts go, i was able to use the ones out of the yukon xl in my tahoe. -
B
Swapping Yukon XL Captain chairs with Seat Rails from 03 Escalade. Trying to fit in 05 Tahoe.
Yes sir, they are indeed. Ive got one seat complete. I will post all the details with pictures when i finish with the second seat and get them in the Tahoe.
