2002 5.3 Crank appears to wobble at idle

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

2

2006Tahoe2WD

Full Access Member
Joined
May 24, 2015
Posts
467
Reaction score
293
Location
Silicon Valley
strutaeng said:
That's the correct procedure. After Step 7 you are supposed to check the measurement between the pulley where the bolt mates and the crankshaft snout.

The 240 ft-lb and 140 degrees tightening is a bear. I just installed mine on an engine I have in a stand. My 24" digital torque wrench was 24" too short! LoL

"Maybe" you should consider replacing the front cover seal(?) But your engine looks pretty clean. Maybe not?
Click to expand...
Regarding the front cover - I think I'll let sleeping dogs lie. :cool:
 
You must log in or register to reply here.

Similar threads

X
Intermittent No Crank No Start
Replies
8
Views
344
NardDog
NardDog
K
2007 Yukon SLT 5.3 to 6.2 swap, VVT cam replace options, and long tube headers
Replies
1
Views
1K
Geotrash
Geotrash
P
2002 Yukon/Another knock sensor thread
2
Replies
16
Views
5K
Fless
Fless
CruelJung
Rough Idle @ Cold Crank (Worse in Cold Weather) + Fluctuating RPM in Drive
2 3
Replies
23
Views
8K
opfor2
opfor2
S
2012 Yukon XL Denali temperature creeping up at idle only.
2 3
Replies
20
Views
5K
ShakinNBakin663
S

Forum statistics

Threads
129,251
Posts
1,812,854
Members
92,354
Latest member
Off Road Pedia

Latest posts

Top