What did you do to your OBS GMT400 Tahoe/Yukon Today?

Big Poppa Pump said:

Completed my front hub replacement a few days ago. I used Timken hubs. It did not go easy. My bolts were so bad they needed the bolt heads chiseled off and then extracted due to rust deterioration of the bolt head. Only 2 of the total of six (Did both sides) came out clean. I had to pay to get it up on a lift because it was too involved for jack stands. I also had to pay $13 a bolt because I did not have them on hand and had to pay to have them delivered. The good news is that it fixed the problems I was having with wheel movement and the ABS sensor activating when driving low speeds. Now my truck is back to being dependable. I was going to go ahead and change my front oxygen sensors while I was at it but the rust is so bad I had to stop or risk twisting the whole bung out of the exhaust pipe. I guess 173,000 miles of road salt will complicate things. I wish I would have washed the truck more often.

Click to expand...

Dneel81 said:

Getting the 2door back from the alignment shop today I hope. They had it yesterday and called me whining about "whoever did the lift kit left all the bolts way loose." I let him rant for a bit and then told him I was the "dumb bastard" who left the bolts loose, that it was intentional, and that's why I had it towed to their shop to make their alignment easier. I didn't see the point of torquing down misaligned bolts. He didn't have much to say after that. I laughed and told him it was cool, just do the job right. either way I'm back in the 2 door today!

Click to expand...

bowtiefreak said:

Idler pulley, tensioner assembly, Steering position sensor. Like a new truck again

Click to expand...