i know what im doin today then. ha ha. cuz when i got my denali, that strap was missing. so i guess just for giggles i'll make one from some 4ga scrap i have layin about the shop.
um why would you need to ground the hood? i mean, i have the fixed bolt on my hood but no covered cable running from where the chassis ground mounts on the firewall. i always thought that was for a underhood light. lol.
remove the plastic trim cover on the inside of the door, and take a look to see whats binding your handle up. iv'e gone through his twice before, now on my 3rd liftgate handle. i even had to do a qwickie repair on one of those missing pins using a modified cotter pin, while i waited for the...
yes they do come apart. rather easy too. hardest part is getting the glass off without breaking it. a long thin standard screwdriver will allow you to reach the ring tab that holds the mirror back to the motor. there are several tabs in the ring that need to be undone for the mirror come off...
not always are they AWD. my 05 Denali is 2WD and also has a 5.3 not the 6.0, it was a special construct. so you can find them. odd as they are. makes getting parts from the auto houses a bugger.
yeah, did you get any perf parts? cuz i had my trans rebuilt just a few months ago, full tear down, and rebuild, and i was out the door for around 800$ parts and labor and they had to replace ALL my internals. plus that also included an oversized trans cooler, and corvette servo as well. so to...
if your going to bother to run 0ga to your amp from the battery, then you should forget the 4ga between batts and go with 0ga as well. and do the big 3 in 0ga also.
i did that and still have some play. a lot less than before. so it may fix your issue, however it did not fix mine. so i may just replace the shaft. and the lower bushing as well. but at the same time my steering box may have play in it. i havent ruled it out. truck had a frame repair from...
intermediate shaft.(upper half of the steering shaft) i have the same problem just havent gotten around to fixing it yet. thinking of getting the heavy duty shaft, but is it really worth the $280? i mean, do the needle bearings make that much of a difference? the stock replacement is only, like...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.