Search results

  1. mikeheff

    Help needed...What should I do next?

    I have unplugged every sensor I can think of, maf, iac ,iat, egr, its runs better with any of these unplugged and the tps code does not come back unless I plug the one I had unplugged back in. Any ideas?
  2. mikeheff

    Help needed...What should I do next?

    has anyone ever experienced this before?
  3. mikeheff

    Help needed...What should I do next?

    today I spent another few hours just piddling on this thing, I cleared codes, figured I would start unplugging sensors to see what made a difference. After unplugging mass air flow, it runs 90% better. No Tps codes set for the first time, trans shifts normal and actually accels great. Thought I...
  4. mikeheff

    Help needed...What should I do next?

    today I spent another few hours just piddling on this thing, I cleared codes, figured I would start unplugging sensors to see what made a difference. After unplugging mass air flow, it runs 90% better. No Tps codes set for the first time, trans shifts normal and actually accels great. Thought I...
  5. mikeheff

    Help needed...What should I do next?

    today I spent another few hours just piddling on this thing, I cleared codes, figured I would start unplugging sensors to see what made a difference. After unplugging mass air flow, it runs 90% better. No Tps codes set for the first time, trans shifts normal and actually accels great. Thought I...
  6. mikeheff

    Bad ECM ?

    Have you checked e grounds, one at tstat housing, also make sure the power supply to fuse box is tight.
  7. mikeheff

    Bad ECM ?

    Have you checked e grounds, one at tstat housing, also make sure the power supply to fuse box is tight.
  8. mikeheff

    Help needed...What should I do next?

    the wires at the tstat housing are secure, a little green in color, but not corroded like you would see on some battery terminals..no fuzzies or anyting
  9. mikeheff

    Help needed...What should I do next?

    I have them, but understanding them is my problem. I have had the gm guys at my work look at it several times, they are stumped as well. Their guess is another sensor is causing the issue, something that does not require a 5 volt reference
  10. mikeheff

    Help needed...What should I do next?

    I will check it out , thanks for helping !!
  11. mikeheff

    Help needed...What should I do next?

    temp on tech II reads 188 degrees, dash reads right at 200 ish.. grounds from motor to frame appear good, I need to check the one on tstat, didn't know one was there, thanks..can spider injectors , intake or throttle body cause this?
  12. mikeheff

    Help needed...What should I do next?

    today I put on new coolant temp sensor, just cause t shares ground with tps. I also installed new ac delco spark plugs, just because, I knew this had nothing to do with tps problem, but why not, right? I double checked all pins and still, The Damned TPS code still comes back, runs like dog...
  13. mikeheff

    Help needed...What should I do next?

    Ok guys, I finally got the ecm programmed at GM dealership. The same problem is there, sets tps code low voltage. I'm lost! new genuine tps, rewired straight to ecm, replaced ecm and programmed. any ideas? even GM had no positive input.
  14. mikeheff

    heated seats?

    thanks for the info!
  15. mikeheff

    Fender Flares coming loose

    its a combo, bolted underside, taped above
  16. mikeheff

    heated seats?

    aftermarket will be most cost effective , is the wiring pretty basic ?
  17. mikeheff

    Fender Flares coming loose

    3m tape? anyone?
  18. mikeheff

    heated seats?

    Has anyone ever installed heated seats in a 1996 Tahoe? If so, details?
  19. mikeheff

    How many miles do you have?

    199,857 on 96 old school
  20. mikeheff

    New to site with my recent 1996 Tahoe purchase

    Hey everyone, Thanks for letting me be a part of this site. I have found a lot of good info and advise so far. I got my 96 last fall and have been tinkering on it ever since. The asking price for it was 3k, I walked away with it for 1650.00. Its a 4wd, 4 door with 3 inch body lift and 285/75/16...
  21. mikeheff

    Help needed...What should I do next?

    Thanks again for your help, I will post how its doing after the programming later this week
  22. mikeheff

    Help needed...What should I do next?

    You would be correct, I called the used yard I got it from and they said was off blazer with 4.3 L.
  23. mikeheff

    Fender Flares coming loose

    I have a 1996 4 door with original factory equipment fender flares, they are coming loose at the top. What do you guys recommend to repair? I need to remove them from Tahoe, but don't want to until I get advise on what to do to clean and reseal with. Thanks !
  24. mikeheff

    AC issues 2000 limited

    my thoughts are not correct amount of refrigerant, orifice tube or high pressure switch. what are the readings on a/c gauges?
  25. mikeheff

    Help needed...What should I do next?

    Thanks, I am taking in this Thursday for programming. Is it normal for the donor pcm to run very rough until programmed. I got one that had same serial # as mine, but off different vehicle they told me.

Forum statistics

Threads
137,709
Posts
1,990,140
Members
102,701
Latest member
vsaravia

Latest posts

Back
Top