Recent content by pm80
-
P
Let's see some pics of some lifted and leveled
CCM leveling kit next to a stock one Sent from my iPhone using Tapatalk- pm80
- Post #89
- Forum: Lifted Supension - Z71 & 4x4
-
P
Trade-in
Well thanks for the replies. Not what I wanted to hear. Sent from my iPhone using Tapatalk- pm80
- Post #5
- Forum: General Discussion
-
P
Joining the NNBS club
I did my CCM by myself and it took me less than 4hrs Sent from my iPhone using Tapatalk- pm80
- Post #17
- Forum: General Discussion
-
P
Trade-in
I have 07 Yukon slt. Has everything but sun roof/nav/ and backup camera. 85k. Clean car fax and paint is good. Been offered 13,500-15000. Is this about what they are worth. I would think more? Sent from my iPhone using Tapatalk- pm80
- Thread
- Replies: 6
- Forum: General Discussion
-
P
Door trim
Used goo gone and lots of rubbing with my finger. It took a while. I like the results. I got some adhesive remover from the parts store. It worked good, but I think the goo gone worked better. Also get some emblem glue. You have to move them down or it doesn't look right in my opinion Sent... -
P
corvette servo for a 2008 tahoe ltz
Felix the ebay add is only for 3-4th you need to the corvette servo also. Also bb recommends you do it before tune- pm80
- Post #24
- Forum: Performance
-
P
vette servo
Just curious why you recommend to put in before tune? I have been doing alot of reading about it and just wanted your input as I plan on getting a tune in the future.- pm80
- Thread
- Replies: 3
- Forum: Black Bear Performance
-
P
Tires and Wheels w/ 4" Lift
I have a ccm leveling kit with 20x9 rims with a +16 backspacing and am running a 305/50/20 tire. It rubs in one little spot. So you can go bigger than that with the 4" lift kit. I would not go with a 17 or 18' rim you will regret it latter. They are too small for this big of a truck. hope this...- pm80
- Post #2
- Forum: Lifted Supension - Z71 & 4x4
-
P
installed ccm 2.5
The wheels are MB motoring Yuma's. I did install the rear spacers and it was really easy. I put jack on both sides and took one wheel off at a time. It dosen't say to in the instructions, but you have to unbolt the sway bay to get it to drop low enough.- pm80
- Post #6
- Forum: Lifted Supension - Z71 & 4x4
-
P
installed ccm 2.5
My rims have a +16 offset and barely rub on one side. I don't think they rub at all on the other side. I think with that tire you should be fine. Also it only rubs on the inner plastic and not on the lower valence or the side steps. Your tires would be a tadd narrower and with the stock wheels...- pm80
- Post #3
- Forum: Lifted Supension - Z71 & 4x4
-
P
installed ccm 2.5
07 yukon 305/50/20 terra grapplers and corsa sport- pm80
- Thread
- Replies: 6
- Forum: Lifted Supension - Z71 & 4x4
