Recent content by Pete315
-
P
2003 Yukon clunking from rear when both tires off the ground
I changed the rotors and rear brake pads 2 weeks ago. I had a scraping and squeal from left rear brake. I took everything apart and discovered one of the new rotors I got was severely warped. The rotor was actually hitting the bracket the caliper attaches to. Autoparts store replaced the rotor...- Pete315
- Thread
- Replies: 2
- Forum: Engine & Drivetrain
-
P
BCM needs changing
I have one last bug to fix on a newly acquired 03 Yukon. The message left rear door not closed comes up on screen which in turn causes the interior lights to always stay on unless I manually push the button on the light switch to turn off the interior lights. I tested the door switch and get the... -
P
Odometer just went to zero
I replaced the cluster. Now the temp gauge and tach works properly. The seller of cluster programmed my mileage into the cluster and that works also. -
P
Odometer just went to zero
that's great info. I appreciate the response. I'll let everyone know the results after I install the cluster. I also lost the engine hours. It showed engine hours and proper odometer reading yesterday. -
P
Odometer just went to zero
I'm having a problem with my 03 Yukon. The temp gauge doesn't work so I just ordered a new dash cluster. I get in truck today and start it up and the odometer goes to zero miles. The tach works but is reading really low. At idle, tach reads maybe 200 rpm's. Also, I get a left rear door open but... -
P
Temp Gauge
I do have the 2 prong sensor. My 81 Corvette had a 1 prong sensor. I know the Corvette would send the different resistance to the gauge from this 1 prong temp sender as the car warmed up. But with 2 prongs and 2 different color wires, I thought one wire would be power, maybe not a full 12 volts...- Pete315
- Post #12
- Forum: Audio & Electronics
-
P
Temp Gauge
I also have temp gauge not moving off 160. I removed the plug from the 2 prong temp sender. Question, how do you ground out the pigtail? I used my test light and with key in on position, I have no power on the gray wire. I used a paper clip and stuck it into each terminal of pigtail. I figured...- Pete315
- Post #10
- Forum: Audio & Electronics
