Recent content by MrBlonde

  1. M

    Project Dadnali

    Initial butt dyno says yes. Once I have time to get them dialed, it will be an “absolutely”
  2. M

    Project Dadnali

    All that’s left now, is to plumb the bags to the stock compressor, and perform a ride height re-learn.
  3. M

    Project Dadnali

    Fun side by side of my stock Denali xl spring, vs the Dobinsons. Note that the Denali spring is sitting on a 1.5” suspension maxx spacer.
  4. M

    Project Dadnali

    Quick run to the gas station to fill up and feel it out. Very different feel vs stock, and in line with what I was after. Forgot to get pics of the sway bar install, but I’ll be adjusting the stiffness, and will get some pics then.
  5. M

    Project Dadnali

    Shock and spring in. I had to trim the liner, and hammer the rear liner mounting tab flush, in order for the resi+adjuster to clear.
  6. M

    Project Dadnali

    Rear spring+bag in. I had to disconnect everything from the rear axle except for the upper arms, to get enough droop.
  7. M

    Project Dadnali

    Rear end parts all ready for install. Now, to find the time.
  8. M

    Project Dadnali

    Under its own weight. Ready for an alignment.
  9. M

    Project Dadnali

    Driver side, when I switched to the passenger side. Swaybar, electronics clean up and final torque spec happened after both sides were “done.”
  10. M

    Project Dadnali

    Life threw me a huge curve ball, so I’m a bit behind schedule. In my haste to get things done, I took very few pictures. But, the front end is done. Parts ready for install
  11. M

    Project Dadnali

    Greetings everyone, long time lurker, first time poster. Here to share the saga of my incoming 2019 XL Denali upgrades. My current pile of parts to install: 2.5" Kings all around Dirt King Ball joint UCAs Dobinsons C09-045 rear springs Airlift helper bags, plumbed to the stock compressor and...

Forum statistics

Threads
134,767
Posts
1,907,844
Members
100,148
Latest member
DaveBYukon
Top