gtrslngrchris's latest activity
-
For those not following my build thread, I learned from another 3500 owner what the correct hitch is for these if you want to go to a... -
gtrslngrchris reacted to Walkerfever's post in the thread What did you do to your 2015-2020 K2XX Tahoe/Yukon Today? with
Like.
Weather was beautiful after work today, so my son and I finally installed the front sway bar and end links. Came out great, and went... -
gtrslngrchris replied to the thread Competition Mode active.Competition mode on Corvettes is basically you can slide the rear end without it trying to immediately gain traction and murder you but...
-
gtrslngrchris reacted to k_arnold72's post in the thread What did you do to your 2015-2020 K2XX Tahoe/Yukon Today? with Like.
I have FINALLY got ahold of a MPVI3! E85 is in my sights. Just have to figure out hptuners procedure, then I'll be on my way
-
gtrslngrchris reacted to Jeff_'s post in the thread What did you do to your 2015-2020 K2XX Tahoe/Yukon Today? with Like.
Got home from a 3600 mile drive up to north Idaho, Montana and back. Truck ran solid and didn't skip a beat. I had cruise control set at...
-
gtrslngrchris reacted to Walkerfever's post in the thread What did you do to your 2015-2020 K2XX Tahoe/Yukon Today? with Like.
Installed the rear sway bar, front will be coming once I find some replacement 38mm bushing for it.
-
Rear end parts all ready for install. Now, to find the time.
-
Driver side, when I switched to the passenger side. Swaybar, electronics clean up and final torque spec happened after both sides were...
-
Under its own weight. Ready for an alignment.
Forum statistics
Latest posts
-
-
-
2010 Yukon 6.2L DIY DOD Delete / Engine Rebuild - Starter issue
- Latest: jjmasterson
-
-