Recent content by dmdonjuan
-
D
hesitation at 65
pcv valve The only thing i found wrong so far was my new pcv valve was bad. Still troubleshooting.- dmdonjuan
- Post #6
- Forum: General Discussion
-
D
hesitation at 65
its a 96 hoe, 5.7. the intake gasket failed so i installed the new csfi while i had it apart. the stock set was not re-usable. i will try raising the rpms again and check timing. no fuel odors, good compression, going to check fuel psi today, and wiggle some wires. thanks for your help.- dmdonjuan
- Post #5
- Forum: General Discussion
-
D
CrankShaft Position Sensor Adventures...
sweeet, i will check mine. what kind of steering stabalizer do u have?- dmdonjuan
- Post #2
- Forum: General Discussion
-
D
hesitation at 65
ac-delco [email protected],TPS votage good,timing on a scan tool was at -21--23. auto zone scanner, engine running. couldnt get a reading of +-2deg,. went over every connection,vacuum lines, grounds, etc. fixed abs sensor, front left ohmed open, easy check and fix. seems to run a little better on...- dmdonjuan
- Post #3
- Forum: General Discussion
-
D
hesitation at 65
ok, new fuel inj. conversion,msd wires,cap rotor,plugs,fuel filter, ground wire, optima,etc. sputters @65 +. k&n is new, no codes. vacuum check normal, plugs look fine,wires ohm out ok.no vacuum leak i could find. i had a multi cly ? code 1 time(cant remember code) p1080 i think, but cant throw...- dmdonjuan
- Thread
- Replies: 5
- Forum: General Discussion
-
D
MFI upgrade
i just did mine, O'Reilys auto 300.00. i still have my old one, will look at it and let u know if i can see a difference.. any pitman arm removal tricks out there,??- dmdonjuan
- Post #20
- Forum: Performance
