Dirty looks's latest activity
-
Dirty looks replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Roo Roof vent is in, but not trimmed and wired. Cutting a hole in the roof for some reason causes anxiety.. -
Dirty looks reacted to Doubeleive's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Like.
Semi annual engine cleanup/degrease -
Dirty looks replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Installed my Baseline Overland rack this weekend. Along with 3 Renogy ShadowFlux 110 amp solar panels. Still need to cut the hole to...
-
-
Dirty looks reacted to rdezs's post in the thread Front Axle Seals replaced...still leaking with Like.
..... If the seal is spinning with the axle.... That is an obvious problem.
-
Dirty looks reacted to rdezs's post in the thread Front Axle Seals replaced...still leaking with Like.
No, not correct. Sounds like you have the wrong seals. Sounds like too small of a diameter for the axle shaft, gripping so tight it...
-
Dirty looks replied to the thread Spare Steel Wheel Replacement.
-
-
Dirty looks replied to the thread Spare Steel Wheel Replacement.My '07 has an aluminum rim for the spare. It lived under there till last year and is in great shape. Possibly find one of those?
-
Dirty looks replied to the thread Replacing torque converter without a lift and using floor jack/trans jack, what is needed?.I can tell you that the balance point with the transfer case attached is just in front of the cross member. A floor jack, a short 2×4...
-
Dirty looks replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Looks beefy..
-
Dirty looks reacted to Charlie207's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Finished the last 10% of the bumper build. Got the little extra steel parts welded and painted, the light bar mounted and wired, and...
-
Dirty looks replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.The only time I ever found the factory fogs useful was the first time I went to Moab and did some trail running at night. Help to light...
-
Dirty looks reacted to Scrappycrow's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
You have a much higher opinion of the factory fog lights than I do. They're only 25W or so, and the pattern isn't great.
-
Dirty looks replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.When I did it I wedged a long prybar in there and used a floor jack to force the pipe out of the way. The flex coupler was a flexing...
-
Dirty looks reacted to Scrappycrow's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
The standard advice (and which is what I resorted to for my first and so far only trans filter change) is using a big pry bar to force...
-
Dirty looks replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Played around test fitting on the ultimate adventure vehicle. RPD rack and propane carrier. Overland Vehicle Systems trash bag, Open...
-
