Just installed a JBA header on the driver side. I pulled a donut from the setup. The JBA header has a ball on the end. Do I just connect the old pipe to the ball on the new header? Any gasket?
I can get you a shot when I get back from NO. I bet they are 16x10's. I wouldn't mind going to a narrower rim if it help with the rub. Any ideas on the lift as well? Trying to figure out what I have with it too.
They are not stock rims. I have some pictures of the lift I'll post tomorrow morning. I'll also take pictures of the rims. They are deep dish and rather wide. I appreciate you helping me out.
I am lifted some. Have what looks like a 4 inch lift maybe? I need to post some pics so I can figure it out. The wheels clear now barely with the torsion bars cranked. What would you suggest for width and backspacing?
Went ahead and purchased the LT coated pacesetters. So now what would be the best for the back end? Headers to a y or x-pipe? Cats or no cats? 2 mufflers or 1?
I am looking for a set of longtubes. The only set I have found is the Pacesetter 72C2262's. The only other set is the ****** 2462's? Are these even compatible?
I have a 99 2 door with the 5.7 and EGR, no AIR.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.