Recent content by 05gto
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
I agree with suggestions now on pcv. This makes sense. Looking forward to testing.- 05gto
- Post #26
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
I never had any oil leaking problems before the rebuild song doubting, at least hopefully that it's not a casing issue. I'll try and check the other suggestions later this week when I'm able to work on it again. Thank you for the insight- 05gto
- Post #23
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
I have to check this Sunday when I get to work on it again. Thank you- 05gto
- Post #22
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
Did it with stock pan, accidently broke a bolt on oil cooler like that then subsequently broke an extractor. I then replaced with a Dorman- 05gto
- Post #16
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
It's been a complete rebuild. Have replaced pretty much everything. And yes, I did use RTV on the corners only.- 05gto
- Post #15
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
It's really only from about 4 inches of the front and back and both sides that it's leaking. Though more from the passenger side than driver. When I get a chance to check again I'm going to see if the rear plate is lined up correctly. Wondering if it's possible that the plate is hanging lower...- 05gto
- Post #12
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
Yes, I plugged it. Wondering if I should put the relief valve back. I've heard that only helps with afm, so I'm not sure- 05gto
- Post #9
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
Definitely not front. Dry as a desert. Flywheel is dry as well because at first I thought it might be rear main seal or rear plate, but that area seems dry as well under Trans bell housing.- 05gto
- Post #5
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
That was my thoughts as well with valley cover. Changed it and the gasket. Changed valve cover gaskets as well. It's been a gremlin. Doesn't leak even after rpms a raised. Only after engine load in drive.- 05gto
- Post #4
- Forum: Engine & Drivetrain
-
0
Oil leak from Oil Pan and Oil Pressure Relief Valve
I'm having an issue where oil is leaking badly from oil pan during load. Have a 6.2L 2012 yukon that has been rebuilt with dod/afm delete as well as vvt delete. Bought Part# 12710304 Oil Pump directly from GM. Getting close to 70 psi oil pressure idle on cold start. Around 40 when warm. Under...- 05gto
- Thread
- Replies: 40
- Forum: Engine & Drivetrain
