Hey I know this may sound like a long shot and some things may not seem so obvious only because I have seen this before but is the belt missing that drives only the compressor ijs
Check your radiator when the engine is warmed up your radiator should warm from top to bottom if not it may be clogged you can flush it but it may be better to replace it and the thermostat along with the anti freeze lol....some people believe you should reuse the old stuff smh...
Okay out there looking for the vortec experts...I have a 2004 Denali and I have an oil pressure and not sure which way to go with engine cold pressure hovers around 30-40 and as the engine warms up slowly starts to go down now I haven't put a mechanical gauge on it yet but I have replaced the...
Hub bearing
Sounds like you have a bad hub bearing I would jack the front up and wiggle the wheel around you will surely find it also it is recommended to replace both at the same time that way they should have the same life expectency...
There are 4 screws on the back of the console behind the cup holders the you have to remove the arm rest door and then remove the tray inside the center console once you remove the inner tray then you will see two more screws in the top that holds the back panel on the seat heater switches are...
Wheel bearing test
You have to jack the front of the truck up support whichever wheel you think is the problem and rock the wheel up and down and side to side that is how you can verify a bad wheel bearing they don't always give codes....
I have an 04 denali with over 200,000 miles,mine just started doing that and I put it in the shop they told 2nd and 4th gear were gone so time for rebuild you have the same symptoms that I had....good luck
Yes that is the incorrect center console that is for 95-99 truck not sure of the part number for the newer body style but check eBay or your local boneyard...
You can unplug the cluster and when you plug it back in they should do a sweep test but your cluster is probably bad check this site"Florida speedometer.com"
Sounds like your alternator is bad if you have a scanner most of your more expensive scanners can read output voltage from your alternator you also can check at your battery with a digital volt meter but the old school method is to start the truck and then remove the negative terminal if the...
My cluster went dead the same way I unplugged it and plugged it back in and it was fine for about a week and same thing went dead again not promoting the guy but check "Florida speedometer" he will take care of you... Sound like your cluster is going baddddddd
Not sure if you have tow hitch and wiring but you can check there also and there is a connecting block up under the right rear corner of the truck check there to make sure all the plugs are in good and tight...
It is most likely the oil sending switch had the same problem oil pressure gauge pegged out and thought it was cluster but after replacing that sending switch the problem went away....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.