Any news on the U joints? The weather is getting hot here and my problems seem to be more noticeable with the higher temps and AC on. On a different note I came across this post this weekend.
http://www.iatn.net/techhelp/69/27659/2007-gmc-yukon-denali-6-2l-hesitation-misfire-shudder
Im not...
Id love to know if you find anything. Our truck really doesn't get on the hwy too often. City has always been 12.9. What mpg were you getting before this problem?
I never did a follow up. My Maf replacement only fixed/masked it for a month or two. It came right back and comes and goes. I have cleaned the new MAF with no results. The weather was in the 60's this weekend. No AC on - and it was doing it on every little incline with light throttle input...
Update
I checked the balancer while running - it looked smooth. Next took the maf out to clean it again. I noticed it was clean but that two of the three little bars with the resistors? on them were black. Almost burnt looking. Must not have noticed when I last cleaned it. Found a new...
Hi guys,
Thanks for replies. Retired sparkys explanation is exactly correct. "a situation where the engine is slightly lugging when the crank/flex plate is working against increased torque load until the tranny shifts to a lower gear."
Some more information - I have recently replaced...
Our 2008 Denali is experiencing what I believe to be torque converter trouble. Most of the time I notice it when cruising in the 35-40mph range at low rpm (1300 or so rpm) – when you encounter a slight incline it will shudder so bad that it feels like you are driving over rumble strips. As...
I finally broke down and took it to an auto electrical diagnostic shop today. After a couple hours they said the tccm was shot. The same TCCM that I just paid a local Chevy dealer to reflash last week. The diagnostic shop quoted a large sum to put a new gm tccm in and program it. I asked if...
Recently bought a used 2003 Tahoe - 4x4 worked intermittantly. Bought on the cheap. Seller had quote from dealer to fix 4x4 for around 1100(reflash tccm and replace encoder). Service 4wd message was always on the dash. Dealer said code was C03-27 i believe. Truck was always stuck in 2wd...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.