Search results
-
D
2017 Tahoe Harsh Downshift with Pop
Hello 2017 Tahoe 5.3 with 118k miles, bought in Jan with 111k miles. I have been noticing a harsh downshift when braking and almost like a pop sound from 2-1 when braking. Transmission fluid and filter was replaced right when I bought the car. No codes. I got a custom tune which has helped but...- davidkramer
- Thread
- Replies: 6
- Forum: Engine & Drivetrain
-
D
Key Fob Issues and Hood Open Warning
2017 Tahoe with 114k miles. On the key fob, sometimes the remote start will not work (all other buttons will) and other times it will work but as soon as I press the unlock button after, it will shut the engine off. I have tried a new key fob and new fob battery with not fix. Car battery was...- davidkramer
- Thread
- Replies: 1
- Forum: Audio & Electronics
-
D
17 Tahoe Front Suspension Noise
Just updating everyone: It was the front sway bar bushings. Mechanic replaced them with OEM and added DynaLube as well. I had him replace the rear ones too as he had the car up on the lift even though they were not making noise. Thanks for the fix!- davidkramer
- Post #5
- Forum: Street Suspension
-
D
17 Tahoe Front Suspension Noise
Thank you, I ordered new ones with good grease and my mechanic is replacing it when he paints my wheels.- davidkramer
- Post #4
- Forum: Street Suspension
-
D
Black Friday Sale!
What is your average hp and tq gains on 87 octane for a 2017 Tahoe RWD?- davidkramer
- Post #7
- Forum: Black Bear Performance
-
D
17 Tahoe Front Suspension Noise
Recently traded my 08 Tahoe for a 17 Tahoe and love it. Bought it from a Ford dealer and they did some work to it before selling it to me including replacing the rear shocks. Didn't notice until now but when I go over bumps/dips, the front suspension has a horrible creak for the first 10-15min...- davidkramer
- Thread
- Replies: 4
- Forum: Street Suspension
-
D
2008 Tahoe P0300, Rough Idle After Work
UPDATE: Friend pulled the head off and replaced the all the lifters on the driver side, replaced the head and valve gasket, with the same brand. Tahoe runs great now with no hesitation, no misfire and full computer diagnostic is perfect. He sent the lifters (Meling) and head gasket (FelPro)...- davidkramer
- Post #17
- Forum: Engine & Drivetrain
-
D
2008 Tahoe P0300, Rough Idle After Work
Thank you. He purchased the lifters for both sides from RockAuto, I don't remember the brand but I believe Millings because that's what the oil pump is. He is going to take the valve cover off on Friday and check for the rocker arms and take the head apart again if that seems fine. I have the...- davidkramer
- Post #11
- Forum: Engine & Drivetrain
-
D
2008 Tahoe P0300, Rough Idle After Work
Thank you. Did it have any specific codes on it that you remember? I will do this in the AM- davidkramer
- Post #8
- Forum: Engine & Drivetrain
-
D
2008 Tahoe P0300, Rough Idle After Work
My friend did the work. I asked him and he said "the camshaft looked fine and none of the push rods were bent". I will ask him about the lifter wheels in the AM.- davidkramer
- Post #7
- Forum: Engine & Drivetrain
-
D
2008 Tahoe P0300, Rough Idle After Work
Yes. I had lifter noise for the past 6 months getting worse and I had low oil pressure that rose after driving, indicating the o-ring failure. Instead of just replacing the failed lifter and o-ring, I had my friend do the oil pump, all lifters, head gaskets, plugs, coils and wires while he was...- davidkramer
- Post #3
- Forum: Engine & Drivetrain
-
D
2008 Tahoe P0300, Rough Idle After Work
Hey ya'll I had my oil pump, pickup tube, lifters and all gaskets replaced on my 2008 Tahoe 4WD with 120k miles on it. About 5min after driving it, I had a service traction control/stabilitrak light and P0300 light come on with a rough idle. Looking at my computer, it is saying Cylinder 1 and 7...- davidkramer
- Thread
- Replies: 16
- Forum: Engine & Drivetrain
