I will do 5100's in the front at some point. Truck has 53k miles on it now so I decided to wait a little bit. Getting it to this point was an investment and I didn't have to disassemble the coil overs at this time. So I waited on the front shocks. Got it cleaned up and took pictures with the...
Thanks man! I'm more than happy to provide info!
I did use 5100's but only replaced the rear shocks.
The longer sway bar end links are made for a Jeep. I got the info and part number here on the forum. They worked great! I bought them a long time ago but I could dig up the details if you...
Two wheel drive, 3.5in CST lift spindles with a shock spacer up front for 4.5in total lift.
3in coil spacer in the rear. Longer bilstein's, longer sway bar end links, and adjustable panhard bar from spohn.
285/75r17 nitto ridge grapplers on 17x9 0mm offset XD misfits.
Nfab steps.
Had to do a...
Got the tires to clear!!! Trimmed, cut, bent, and tied back everything I could and its got plenty of room now!
Front fender height is 40 and 5/8 inches
Rear fender height is 41 and 1/2 inches.
I been working on it most of the week but now it's done and it's done right! So happy!
I'll post...
Awesome! I worked on that today!
Also did the nor cal large fender mod behind the wheels. Now I need to cut the tip off my new Nfab steps. I stuffed these wheel wells! Gonna be worth it in the end though cause it looks right!!!
I went with 285/75r17 (says 34x11.5 on the sidewall) on 17x9, 0mm offset wheels.
I will be doing some trimming to the front and rear of the front fenders he tomorrow. It rubs too bad to drive right now.
Whew! It's been a minute but I finally got around to this yukon project! It turned out great thanks to the information I received from this forum! Pics coming!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.