I am in the process of completely rebuilding the steering/suspension in the front of my 1996 Tahoe LS. I have already purchased all my Moog hardware parts but now I need to look into control arm bushings.
What is better? Moog or engery suspension? Are moog bushings urathane? This is pretty...
Well its been a week since my new radiator install, no loss of any coolant or oil. Would it be safe to assume my intake gasket is good? I have no way of telling if this was done before I had the truck and it has 160k on it now. When I installed the radiator I powerwashed the engine bay super...
There is a cabin filter on the other side of the evaporator coils, all it is 2 pieces of window screen with a plastic mesh in between. I cheated and replaced my evaporator coils when I snapped both AC fittings off in front of the firewall and put a new blower motor in, Im good for a few MONTHS lol
Quick question before I tackle this tomorrow or sunday, Can I take the compressor off and dump out any remaining oil and just fill the system with 8oz of pag 150 oil and regular freon cans with no extra oil in them?
Also if I go with the first suggestion *3oz in the condenser* instead of...
This happened to me too, If it looks identical to the old one it should fit. Mine almost refused to go in, make sure to put a dab of mineral oil on the o-ring and just keep trying, it WILL go in.
The new tires... about 5K.
My old set of tires did this also but they were also recalled for some defects. Its probably been like this for 2 years. When you put the steering wheel straight the passenger side looks fine but the drivers wheen its kicking out at the front quite a bit and thats...
Today I was checking the tires.... both front tires have lumps all around the outer tread. They only been on there for about 6 months so something is wrong, did some investigating and found 1 of my front outer sway bar bolts snapped in half.
With the 1 bolt broken will it cause the wheel to...
Will the 3oz between the 3 R134A cans I have be enough? each one contains 1oz of oil. I bought the high mileage R134A stuff since I am using the compressor thats on my truck, (I dont know how old or how long its been on there)
And which one is the the condenser inlet? top or bottom?
Not yet, I am afraid if the intake gasket is bad any internal coolant leak will destroy my new/existing working o2 sensors. Seams like you cant fix anything on these without destroying other parts new or used. So where do I start? lol
I just got done installing my brand new radiator today so...
I still have no clue what I am doing lol. my luck I'll be putting a new spider in AND an intake gasket job, god I hate my truck. Sometimes I wish I would put the wrenches down and drive it till it completly dies and move on lol.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.