Recent content by camperhead

  1. C

    Radiator fans issue

    2015 Suburban 5.3. My fans are staying on after you shut truck off. Both fans seem to be running at high speeds. They will run till the battery draw cut out shuts them off. IT is around 40's right now here. Got on internet and lots of guys talking about replacing sender that is near the...
  2. C

    2015 Drivers seat lumbar

    2015 LT Ive got a problem with the drivers seat lumbar. For me it doesnt seem to come out far enough. It retracts and extends OK but just doesnt seem to go out the same as the passenger side. Any ideas or experiences??
  3. C

    2015 Suburban..tune up time

    Ive got a 15 with 130K. Tune up time..... Whats everyones thoughts on spark plugs. Currently Rock auto is out of ACDELCO 41114, they have NGK 4344 and couple different Denso's. I have ran NGK in my older gen 5.3 no problem....... Thoughts in this gen 5.3? I am replacing plug wires too...
  4. C

    2015 No crank

    Well I found it. I had taken up.the 12v relay and fuse panel from the base under the hood at one point. So I went back and started rechecking everything i had done. And there she was one single pin bent over. Straighten it out reassembled and reconnected battery. Lots of time and worrying...
  5. C

    2015 No crank

    Ive got a 2015 Suburban That will not crank. Now. It has a brand new battery with 12.8 V. all the gauges come on and do a sweep, windows will go up and down, locks, unlocks, rear gate goes up and down. Security light on dash flashes when you lock doors and shut them. goes off when you unlock...
  6. C

    2011 running poorly...

    What am I looking for undervalve cover???? watch rockers to see if lifter is collapsed? I ordered a new CANdi off amazon. In mean time I borrowed a snap-on from a buddy. should have new CANdi monday. We are taking this truck on trip soon and I want to start making head way on figuring it out...
  7. C

    2011 running poorly...

    Only active code I have is P0300. Cylinder 7 is mis firing WAYYY worse than others. I do have P0420 and P0430 in history codes.... both downstream O2 sensors are showing consistent high value though. Any Thoughts
  8. C

    2011 running poorly...

    The only active code it is throwing P0300. Cylinder 7 has alot of misfire activity... Cylinder 7 is not a DOD cylinder correct?? It did show P0420 and P0430 in code history however.... Both banks downstream show a consistent high value... Thoughts?
  9. C

    Tech 2 Problem

    I'm not sure what you mean by take it apart? Take the ends a part or what? They are clean and very tight to push together
  10. C

    Tech 2 Problem

    Best I can tell it depends on the specific vehicle. GM starting add CAN Bus as they went along. My verison 33.004
  11. C

    Tech 2 Problem

    Ive tried it on three vehicles. First two with the CANdi module 2011 suburban and 07 Duramax, both said" Candi module was not detected for Tech2" then I tried it with no module in a 1998 S10. It connected to it no problem
  12. C

    Tech 2 Problem

    Got my new Tech 2 clone tool today. It will not connect to any vehicle that has to use the CANdi module. I have tried to run the two CANdi test and it fails both of them. Any insights or do I have a bad tool?
  13. C

    2011 running poorly...

    I keep getting message "CANdi module was not detected for Tech2
  14. C

    2011 running poorly...

    Ok. I got my Tech2 it has verison 33.004. Im using the CANdi interface . It will not connect to the truck? Any thoughts
  15. C

    2011 running poorly...

    Thanks for the info guys. i ordered a Tech2 tool should be here the end of the week or first of next. I'll give an update when I determine the issue.
See more

Forum statistics

Threads
129,295
Posts
1,813,398
Members
92,397
Latest member
dzg9

Latest posts

Top