Recent content by 2002DenaliXL
-
2
What is this? Have looked everywhere online. Oil cooler?
That's an aftermarket trans-cooler installed in series of the radiator. Probably put in there to help keep the 60e cooler to help it live a little longer.- 2002DenaliXL
- Post #8
- Forum: Engine & Drivetrain
-
2
oil catch can
As stated above, the PCV system is great for oiling up the intake manifold. When you get time, remove your throttle body and look into the intake with a flash light. You will see the inside has a film of oil all over it. I can post up a picture of my heads (lq4 with 159,*** miles before it died...- 2002DenaliXL
- Post #12
- Forum: Engine & Drivetrain
-
2
oil catch can
I am using Mighty Mouse one. http://www.mightymousesolutions.com/- 2002DenaliXL
- Post #4
- Forum: Engine & Drivetrain
-
2
Who has replaced their lifters? 5.3 T
I don't want to be the bearer of bad news, but if your truck is 11-12 years old and 170xxx miles, I would be leery of the O-Ring on the oil pump pick up tube as well. This is a failure point. Since your in there with the lifters, do it the right way. Cam, Lifters, valve springs, timing chain...- 2002DenaliXL
- Post #8
- Forum: Engine & Drivetrain
-
2
Swap or build?
Its not that bad. I just welded a piece of 3/8" 8" deep C Channel on the back side of the cross member ($10.00) or you can use flat pate with gussets to make it as well, drill holes for new mount, followed the repin for the transmission plug on side, run 2 wires to the PCM (12.00 on Ebay)...- 2002DenaliXL
- Post #10
- Forum: Engine & Drivetrain
-
2
Swap or build?
Here is the motor I am putting in my 02 Denali XL. Did the TBSS Intake and steam ports on all corners, FF 36lb injectors from a new truck, electric fan swap, hydroboost install, EGR delete, 4l80e swap and still kept the NP149 with input shaft resplined on it. The motor it is 460hp with 480lbs...- 2002DenaliXL
- Post #4
- Forum: Engine & Drivetrain
