The BEST exhaust manifold bolts?

[Rocket Man]

3/8" drive Impact sockets? Nah. They don't put out enough to hurt standard sockets.

Hey don’t stop a man from buying new tools!

 

[George B]

3/8" drive Impact sockets? Nah. They don't put out enough to hurt standard sockets.

Good point! Menards has two similar units for the same price as HF.

 

[gooffeyguy]

I have always liked these too but not as much trigger control.
https://www.harborfreight.com/3-8-e...s-torque-compact-air-impact-wrench-93100.html

I have one of those. I've only used it a few times when my 1/2" impact was too big to get into the area

Sent from my SM-G930V using Tapatalk

 

[donjetman]

He's a compact 1/2" that I purchased to remove the torque converter to flexplate bolts when I was doing the rear main seal job.

https://www.harborfreight.com/12-in-ultra-compact-xtreme-torque-stubby-air-impact-wrench-63534.html

 

[gooffeyguy]

He's a compact 1/2" that I purchased to remove the torque converter to flexplate bolts when I was doing the real main seal job.

https://www.harborfreight.com/12-in-ultra-compact-xtreme-torque-stubby-air-impact-wrench-63534.html

Nice, and only requires 5.8 cfm air, so even most smaller 20-30 gal compressors can run it

Sent from my SM-G930V using Tapatalk

 

[Derick]

So quick dumb question on this one..... I got the arp 134-1102 bolts that are flanged and come with washer. Do I actually use the washers on the manifold install?

 

[Rocket Man]

So quick dumb question on this one..... I got the arp 134-1102 bolts that are flanged and come with washer. Do I actually use the washers on the manifold install?

Yes.

 

[George B]

Got these...