98 Yukon, Electrical connector rubber “boot” fell into valve cover oil galley.

[OilBurner2003]

Hey everyone! Yeah it’s me again, I had a tons of folks help me with the intake, and they were all such a great help! But I really think I did it with this one. As soon as I removed the paper towel covering the oil valley in the passenger side valve cover, a electrical connector rubber “Boot” fell right in from the harness. My fault. What do I do to get it out? It’s not visible from the oil valley hole, what are my options do you guys think? This happened when I was finishing my lower intake manifold install.

I made a new post because this is kinda something I want everyone’s opinion on if possible. 24# pages of troubleshooting on the last one is a lot to look through!

 

[89Suburban]

Do you have one of these?

https://www.amazon.com/Grabber-flexible-Four-claw-magnetic-01-Picker/dp/B07BT3X4FV?th=1

 

[OilBurner2003]

Do you have one of these?

https://www.amazon.com/Grabber-flexible-Four-claw-magnetic-01-Picker/dp/B07BT3X4FV?th=1

Nope. Thought I did. Looks like if I remove the lower intake I might be able to see it, probably my only option at this point.

 

[Fless]

Can you blow air into it from another port?

 

[89Suburban]

Do you have a picture where it fell in at?

 

[OilBurner2003]

Do you have a picture where it fell in at?

Hey sorry guys, didn’t get the notifications for these! Ended up ripping out the lower intake, but thanks everyone!