Search results

  1. 9

    lower rather than lift?

    My 2004 SLT 4WD has leveling keys and 285 all terrains on the stock 16's. I intended to start working toward a 2 or 3" lift set up on this rig, but I rarely leave the pavement and started to wonder if lowering might be more my thing. Honestly, I'm a little tired of the rough ride it has now...
  2. 9

    2004 Yukon power loss then normal

    I have a 2004 Yukon 4WD with 210k miles and it's been bulletproof reliable for the past 2 years I've owned it. Running perfectly fine as usual on a 1.5 hour trip tonight, I then made a stop for about 20 mins. Got back in and fired it up, got 100 feet down the road and it started bogging and...
  3. 9

    spacers and bearings

    Do wheel spacers damage your wheel bearings over time? Or is it a non-issue?
  4. 9

    Which 5100's?

    Hey all - On my 2004 Yukon 4x4 I am replacing the rear springs/nivomats with a set of Z71 springs I picked up. I found that there are different versions or sizes of the 5100 Bilstein shocks, so how can I tell which specific one I need to work with the Z71 springs? For the front, the PO says it...
  5. 9

    Z71 and Nivomat?

    I picked up a set of rear Z71 springs but haven't gotten new 5100's yet to replace the Nivomats that are on my Yukon right now. Is there any downside to putting in the Z71 springs for now until I get the Bilsteins?
  6. 9

    Z71 roof rack?

    Hi all - will a roof rack from a 2006 Z71 Tahoe be a direct bolt in on a 2004 Yukon? From what I can tell I think so, but I am not certain.
  7. 9

    Alternator or Battery?

    Wondering if anyone has insights here on this problem.....2004 Yukon, start it up, battery light on and gauge reads about 11 volts. Rev engine and it goes up to 14.5v or so and stays there even after the engine comes back down to idle. I can turn the engine off and on again with the gauge...
  8. 9

    2004 Yukon bench seat

    Hi all - how much is a leather bench seat worth? I swapped it out for captains chairs and I'm going to list the bench on ebay, but can't seem to find many out there to estimate what it's worth. Thanks in advance.
  9. 9

    2nd row buckets

    I've got a 2004 Yukon with the bench seat in the middle. I am looking at a set of 2nd row buckets and wondered, do they recline at all? Also, for those that have 2nd row buckets, would a third row passenger be easily able to use the space between the 2nd row buckets for extra legroom?
  10. 9

    Transfer case fluid - a problem?

    I bought a 2004 Yukon 4x4 about 6 months ago. I'm changing the transfer case fluid today and got Valvoline synthetic transfer case fluid (says it's Auto Trak II compatible) since I have NP8 in my build sheet. I dropped the old fluid and it looks like not-too-dirty engine oil or gear oil. I...
  11. 9

    body molding

    I assume the body side moldings on the doors is just held on by adhesive, and wondered if it's risky to try to take it off (ie damage the paint). Any advice on how to get them off?
  12. 9

    Newbie 4WD question

    Hi all - I got a 2004 Yukon SLT 4x4 a few months ago, and I've not owned a 4x4 before. From what I understand, when in 4H if one of the front wheels loses traction and the rear wheel on the opposing corner loses traction the Yukon will essentially be stuck. I noticed I have the G80 code for...
  13. 9

    Rear glass hinge

    So I've got a 2004 Yukon that had the right rear hinge for the glass break off due to failed factory adhesive/plastic. After reading that it's best to get a 2005 or 2006 rear glass hatch from the junkyard, I wanted to know the best way to go about removing the glass hatch from my Yukon. Do the...
  14. 9

    New shocks for leveling kit?

    Hey all - I've got a 2004 SLT and am brand new to owning a 4WD vehicle. The prior owner said he did a leveling kit up front, so I assume it must mean new torsion keys. I'm looking at getting new front shocks but do I need to get taller shocks or is the stock size okay with the leveling kit?
  15. 9

    service brake system reset?

    Hi - I have a 2004 Yukon 4x4 and I replaced the T55 Torx caliper pins on the front brakes with the 18mm hex head pins. In doing the job, I had to push the pistons in slightly to get the calipers back on the pads. Pads and rotors are in like new condition. When I got done putting all back...

Forum statistics

Threads
128,786
Posts
1,805,388
Members
91,765
Latest member
AT4Hunter
Top