I have found a donor truck for an entire brand new interior for my SLT and it comes with factory heated seats my truck does not have heated seats from factory. I'm grabbing pretty much the entire interior minus the headliner and the rear quarter panel trim pieces. The new door panels have...
I have the gold/tan interior package and I cannot find the front seat back panels. All the clips are broken therefore not allowing it to be reinstalled. My seats are just bare foam on the back. I'm looking for somewhere I can buy replacements. Anywhere I look they are either different types or...
I had to remove my fuse box to access something else and in the process the two clips broke while removal. I'm trying to find out the part number I've search up a bunch but have only found the full fuse box.
I have an 09 Yukon that I'm about to be putting a 16 volt bank. I've already received my bank and alternator. I'm looking for a way to have my second alternator go to my lithium bank apart from the 12volt system. I'm wanting to put a relay in at the alternator I just need a diagram or something...
UPDATE: I have lean codes now for both banks. I am looking for some sort of help getting this tuner set up for my needs. I have a 2009 yukon 5.3 with a Spectre cold air intake and a Diablo intune 3. I had some problems with the intake before so I had to remove it until I could get a tune. Now...
I have a 2009 Yukon 5.3 fuel flex.
I had it taken to a shop because of a code for small evap leak upon taking it to the shop they used a smoke tester on it and were unable to find anything, I have replaced the purge valve by the intake, I have checked my gas cap as well. I'm trying to find a...
After installing a spectre intake my vehicle now runs lean and gives me difficulty starting occasionally. Before installing I a new flowmaster true dual put on and had no issues with only the exhaust. Sometimes throws lean codes P0171 and P0174 but typically at idle or under load, I had the...
2009 Yukon 5.3 Fuel Flex
After installing a spectre intake my vehicle now runs lean and gives me difficulty starting occasionally. Before installing I a new flowmaster true dual put on and had no issues with only the exhaust. Sometimes throws lean codes P0171 and P0174 but typically at idle or...
I have a 2009 Yukon and I purchased the grill set but no matter where I look online I cannot find the matching piece for the hood and I'm trying to figure out where I can buy it from. I would just paint my original but I want to keep them in case I decide to swap it back.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.