Realizing after some reading that the A/C condenser is also the transmission cooler. So you must disconnect/reconnect the lines to the transmission. Curious, do you lose some tranny fluid when you pull the lines off of the condenser/cooler to replace? My understanding is that the transmission is...
Would appreciate any help/input on how involved it is to replace compressor & condenser on 2016 Yukon Denali. My husband did this several years back and ended up disconnecting (and not fully reconnecting) a transmission fluid line...needless to say, it was a problem.
Now the compressor is shot...
Stumbled across this thread on accident, which is weird given I’ve been living this nightmare for the last 6 months (and last $5k to repair shop and dealer)! Best advice is DON’T USE THE BENT FUEL RAIL! First repair shop did after I asked them to check and replace if necessary. The bent rail...
Thanks! That’s very helpful and these guys are way more cautious about a potential leak then the guys that fixed mine!! Wondering if a bent rail would have been noticeable as I specifically asked them to check
Hopefully we go through this one more time and I have a drive-able vehicle again...
Thanks for the reply! Any idea where to get the “special tool” required for removal of the fuel rail? Can’t find the one on Amazon specifically for the 6.2L and not sure if/how it would be different for the one that says it’s for the 5.3L
It's actually the burnt area on and surrounding the cyl. 6 injector. It appears as though it didn't seal fully and is leaking back out around the injector. This started w/ a cyl. 6 misfire code, we were able to track down to the injector. While they had it apart, they suggested replacing all the...
All Fuel injectors replaced at repair shop a couple months ago, had problems ever since and shop threw their hands up, don’t think they ever went back to double check install! Now we remove the intake to find this. Is this a bad install (not sealed correctly) or could anything else possibly have...
Apologies in advance for the long post! Started on this path almost two months ago: flashing engine light. Scanner identified ‘misfire on cylinder 6’. Did some coil troubleshooting (switched a couple), same misfire on cylinder 6, so went down the fuel injector path. Hubby started to replace but...
Very curious if you were able to troubleshoot your passenger side running board. I am having similar issues with mine on my 2016 Yukon XL Denali. The motor sounds a little more "whiney" than that of the driver side. It will retract upon closing the door, but then will go down again after a few...
Just got off the phone with Bill from Xineering and just telling you all to believe the hype - he was great! As soon as I confirm which of the wiring harnesses my husband cut to wire in the resistors (the ones to ride height sensors or the shock sensors), I will have our order in. Apparently...
Huge thanks to all of you for the great info!! Will be ordering the sims (front and rear) here shortly. I do love my Yukon, so am very glad this forum exists. Will have to troll around for some help in diagnosing the "service driver assist system" error too! Thanks again, All!
Looking for some help from anyone who has the knowledge! We have a 2016 Yukon Denali XL and over the past year, the magneride suspension has been increasingly irritating to my husband. So he decided late in the summer to try a conversion kit. He found this "kit" from Suncore: Suncore Industries...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.