Search results

  1. H

    Couldn't decide so I just dropped the rear

    I won't need to worry about that issue. The Belltech drop spring is actually the same length, maybe even a little longer than the stock spring.
  2. H

    Couldn't decide so I just dropped the rear

    Thanks for your info. I didn't mind the slope of the roofline, and your example of the Rover is perfect. It was just a visual thing that didn't look right to me. I liked the result adding the spacer even though it was a minimal amount. That said I decided to just go all in and had a Belltech...
  3. H

    Lowering rear 1 to 1.5 inches?

    Ok here's a pic. I checked the measurements and the final results are a 1.25" drop in the rear. Measured from the bottom of the wheel arch to the ground the front is 36.5" and the rear is 36.75".
  4. H

    Couldn't decide so I just dropped the rear

    Did your drop level out evenly? Your pic looks like its pretty good. I just dropped the rear of mine with the MaxxTrac kit and the rear sat slightly lower than the front. It ended up being a half of an inch lower than the front. I ended up customizing a set of BellTech spacers to fix the...
  5. H

    Lowering rear 1 to 1.5 inches?

    I haven't taken any yet. I did just check to see how much it settled out and it did go down another quarter inch. Which is closer to what I thought I'd get to with the spacer. I'll try to get a pic up sometime this week.
  6. H

    Lowering rear 1 to 1.5 inches?

    I just did this to my 2019 Tahoe. I used a MaxTrac rear leveling kit. Which dropped the rear exactly 2". However I found that it seemed like the rear was just a little too low. Basically slightly reversing the rake, which I didn't care for. To fix it I picked up the Belltech spacer and cut them...

Forum statistics

Threads
137,689
Posts
1,989,656
Members
102,689
Latest member
Woned2004

Latest posts

Back
Top