From what I can tell, the 81250 was spec’d on cars with the Magneride shocks. Is that what yours has?
I have specs for the 81250 further up in the post - the steel diameter is a little smaller, but the spring is a little longer. I don’t have specs for the 81244 currently, and I’m not sure...
Well, 2 years later, I finally picked a spring.
I considered Moog 81244 which as you noted is also cross referenced as the front HD spring. I also considered 81250, and the Dayton CargoMaxx.
The shop that installed for me tested the 3 springs out compared to the OEM spring. My aim was...
I took a standard front receiver and had a welder cut off the part where the drawbar mounts and flip it to above the cross tube. It ends directly behind the front license plate, and I use a receiver-mounted license plate when not using the front receiver to carry something.
Works great and is...
Are you installing Timbrens on the front? I have a pair but have not installed them yet.
I can't recommend the Hellwig kit for the rear enough - so much better than the coils to maintain ride quality as you load it down. I also have Supersprings in my rear bump stops but they basically never...
Thanks swathdiver - appreciate your input. I’ve not given up on spring data yet and have some inquiries out. The 2011+ lack of cross references is curious.
To be fair, the car handled 700 lbs ok, but it was really soft and compressed a lot over bumps and in sharp mountain turns - it was...
I have a 2012 Suburban 1500 4wd LS at 150k miles. I load it heavily - I've pulled a 7500 lb trailer probably 20k miles (boat, to coast and back) as well as sometimes put a couple hundred pounds on the front hitch (bicycles).
At maybe 40k miles I replaced the rear coil springs with Hellwig...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.