I have an 05 Silverado crew cab 5.3L L460E transmission. I am getting codes, 740,758, & P2761.
I did a fluid/filter change two weeks ago and since that time I have been getting the codes. Fluid and filter were changed and replaced with ACDelco transmission fluid.
When I change the fluid in the...
I have been towing trailers since I was 17. Unfortunately I was towing my 5x8 utility trailer and when backing up I managed to jack knife the lip of the trailer onto my rear quarter panel. I watched some you tube videos for cutting removing and installing a replacement panel.
Has anyone done...
I am needing to replace the Ac compressor on my truck due to a bad intermittent ac clutch relay. I am trying to confirm the correct p-nut fitting?
I looked at rock auto and it has either a 12 or 3 position for the p-nut fitting.
Is the p-nut fitting where the pressure line connects to the...
I have the truck at the shop replacing the O2 sensors. They noticed a fuel leak coming from the fuel line above the exhaust. I was very lucky.
I spoke with the mechanic and he said if i can get the two piece fuel line with the bracket it will make installing it a lot easier and less shop time...
I have a bad heater element on bank 2 sensor 2. Code confirmed per diagnostics. Currently it had the Denso O2 sensors. I was planning on installing the GM oem sensors, 213-1699 downstream and the 213-1702 upstream. Should I stick with the Densos? I know own products typically electrical do...
I am in the process of replacing my fuel pump, and charcoal canister. I noticed my brake lines are rusty.
I ordered the dorman complete stainless steel brake line complete kit 195193 i believe it was. Has anyone done this before and was there a process that helped them?
I was planning to run...
I have not trouble codes. I am nto able to fill the gas tank to about 1/2 full. I did replace the Evap purge solenoid in jan of 2018 due to a check engine light.
Has anyone had a similar issue and what was the fix?
Thanks!
I am looking to upgrade the bulbs. Currently stock halogen bulbs. I'd like to keep the stock housings and replace the bulbs. I See Sylvania makes the led fog light bulbs and I think the headlight bulbs to. Has anyone used these or the led plug in bulbs from Amazon?
I appreciate any...
I am looking to add tint to the front driver and passenger side windows. Does anyone have a brand of window tint color and percentage of the rear windows?
I just replaced the fronts on my 03 yukon as the salvsge yard had an exact match.
Thanks,
I have located in great shape four exterior door trim mouldings in white with the center metal trim. I know they have 3m double sided tape on the panels. I will be removingthem from the salvage yard. I don't have an electric heat gun with me. Aside from using heat what else can i do to remove...
I am trying to confirm what are the normal temperature ranges for the rear differential?
I read on the web 125 up to 200 sound right?
Mentioned anything above 225 is not good
I used a IR difgital temperature reader to check it this morning.
On interstate at 65-70 mph and average flat...
Rear pinion seal leaking. I believe it has 8.5 rear main bolt pattern.
Has anyone replaced it themselves and if so the process start to end??
My thoughts,
1. order GM Oem pinion seal using vin #
2. jack vehicle/jackstands
3. mark driveshaft in relation to sitting in driveshaft mount
4. remove...
Anyone know of the bulb watts or bulb parts numbers used in the digital climate control at the dash, overhead climate control for a 2003 GMC Yukon?
I have found repair sites that sell the bulbs for $6each.
Thanks
Anyone know of the bulb watts or bulb parts numbers used in the digital climate control at the dash, overhead climate control for a 2003 GMC Yukon?
I have found repair sites that sell the bulbs for $6each.
Thanks
V8 non flex fuel 5.3L 4x4 crew cab with digital climate control.
Does anyone know what the capacity is for AC R134 in this truck with rear
and without rear ac??
Thanks!
I wanted to check here before posting on a Truck Forum. I am looking at a 2005 Z71 4WD 4-door crew cab with 230,000 miles. It is a one owner. I am asking as it has the same 5.3L V8 motor similar to my 03 yukon 5.3. Does anyone own one or know if this particular model is reliable? I understand it...
Anyone personally own this truck and model year? It has the 6.0 with 175,000 miles with the Quadro Steer. I know the sensor is expensive to purchase used. I can do most of the repairs if needed. Anything to be aware of with the truck???
Thanks!
I am looking to buy a 2006 1500 Crew Cab HD 4x4 with a 6.0 Liter V8 with 222,000 miles.
Can anyone provide the reliability and known repairs required of the 6.0 liter and the truck.
Owner says it has no leaks underside.
It has ride control for towing, air bags.
Issues owner mentioned,
1. oil...
5.3L V8 engine. Cranks/starts up fine. I noticed driving home last night that the volt meter would rise to about 14.5-15 volts and then down to about 14 volts.
I replaced the alternator belt last November when rebuilding the motor.
Alternator was new and installed in Jan. of 2016.
I noticed as...
I forgot to replace the power steering pump when rebuilding my motor/install. I am looking to replace it from Advance Auto. I saw 3 reviews for the reman cardone brand and does not seem reliable.
Has anyone ever rebuilt their own pump?
What new Brand pump would you recommend? Advance has...
I finally got the motor in and running. Yesterday I drove it out the garage and when putting into reverse it makes a loud clunk noise. When switching to drive it does the same thing. Truck has been sitting about 5 months on jack stands, yes 5 months..LOL
I had seen youtube videos of similar...
I am preparing to crank motor and build oil pressure after rebuilding it. Besides the F/pmp relay what other fuses or relays would I remove from the fuse boxes?
The F/PMP relay is under the hood in the black box.
I do see a PCM B located beside the fuel pump relay F/PMP.
ARe those the only two I...
I am in process of rebuilding/installing my rebuilt motor. I had lowered the motor in the engine bay and forgot to slide the driver side exhaust manifold in the engine bay. I had to remove the steering shaft where it attaches to the steering box and upper part of steering. Anyways I removed the...
I am in the process of replacing the ac parts above. It has front digital heater control and rear digital heater control.
Prior to the start of my engine rebuild the Ac compressor was making a whining noise. Shop said it was ok and not detrimental the running it at the time. Anyways with the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.