There is your problem. Says it right there US Battery. Lost 4 custom carts at once all burned to the ground and half of our house at 3am. All the carts had new US Battery 8 volts. Fire marshals determined that the batteries in on the carts was the cause. Not plugged in or anything. Just...
Sorry that was supposed to be 200k. Ive been calling around to wrecking yards and rebuilders today. Pick and pull had one for 300 if you pull it condition unknown sold as is. After that i didn't find one under 800.00 anywhere in close proximity. Found a few on ebay but shipping to texas would...
Have not done a leak down yet. Pvc system is fine. Just replaced the left hand valve cover with the built in valve... My daughter drives the truck to school, home, work etc. I can do a leak dowm but in my mind the amount of oil its pushing out would indicate oil pushing past one of the pistons...
So my 05 z. Has 2000k on it. Starting to have alot of blow by and oil is now pushing out after the dip stick tube once crankcase pressure pushes it out past the oring on the handle. It just started all of the sudden. Never had an issue with this truck since new until the castec heads let loose...
Hello all.... I just put the trans and motor back in my 05 tahoe z71. Of course as it usually goes i thought oh yeah I'll remember how all this wiring goes in and where all the clips and hangers go. But sadly i didn't.. I think i got everything right except for both of the drivers side 02...
Hello all. Got a 2012 with a 6.2. Truck has AFM. Doing a cam swap. I jumped the gun and did not bring the motor to TDC before starting the tear down. Since i was doing a new cam and chain anyway i figured i would that before the install. So now im confused. Got my new cam in already. The cam...
The original pan was about 50 miles. The second pan was probably the same. Third pan was maybe 30 minutes. On the second and third pans. I snugged up all the bolts to the pan. Left them just loose enough so i could shift it. Put the bell housing bolts in and snugged them up first to alighn the...
Hello all. New guy with a question. I got a 2005 tahoe z-71. Recently my 3-4 clutch pack went out. Removed the tranny to have it rebuilt. Had the castec heads that started loosing coolant. So i pulled the motor, new heads. Front and rear main seals etc etc. Put on the pan. Re installed the motor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.