Search results
-
What did you do to your OBS GMT400 Tahoe/Yukon Today?
Replaced my drivers door window motor got tired of banging on the door to roll down the window at the drive through .- Magicmantx
- Post #6,376
- Forum: General Discussion
-
-
Your Vehicles as they sit now....
- Magicmantx
- Post #1,985
- Forum: Member Photos
-
-
My 97 project
I've finally gotten a few road miles on just over 200. I really like the stance and it drives good but the ride is not thrilling. Pretty sure I'm going to replace the leveling kit with a RC Lift soon. Got the console sitting in place and it will work but I need to do just a bit more trimming in...- Magicmantx
- Post #13
- Forum: Under Construction
-
Differential drop bracket
I've seen a couple of diff drop brackets for sale for about $100 anyone use one of these? I installed a supreme suspensions 3-3 kit and managed to get 2" total in the front before the a frames contact the droop stops which is ok but then had to change out the rear blocks to 2" so now it sits...- Magicmantx
- Thread
- Replies: 3
- Forum: Lifted Supension - Z71 & 4x4
-
My 97 project
Next will be pull the seats and work on my sliding mechanisms they are a little tough to slide on the passenger side. Also plan to replace the seat foam on the drivers seat. Also I picked up a nice console from an expedition that I'm going to see if I can fit it in. I replaced all the interior...- Magicmantx
- Post #11
- Forum: Under Construction
-
My 97 project
Finally Back in one piece. Turned out pretty good. Waiting on replacement Grille as mine is peeling a little. In this pic it had 3" blocks in the rear but I took it home and replaxed them with 2" which put me level.- Magicmantx
- Post #10
- Forum: Under Construction
-
My 97 project
Got the grille and Lights put back on and door latches.Stripped out the bolts on the passenger door handle so headed to the boneyard tomorrow for a replacement. That stupin torsion spring on the tailgate took me forever .- Magicmantx
- Post #8
- Forum: Under Construction
-
My 97 project
Getting the shine on. Started on reassembly today starting to look like a Tahoe again.Finally- Magicmantx
- Post #6
- Forum: Under Construction
-
-
-
Please Welcome Rough Country to TYF
this still apply?- Magicmantx
- Post #23
- Forum: Rough Country Suspension Systems
-
My 97 project
I found this 97 in Oklahoma after looking for just the right project to start with. It's a 1997 4x4 . This is a 2 owner Tahoe and both owners were from the same family. The original owner sold it to his sister and after a year she quit paying him so he took it back. he'd already bought a new...- Magicmantx
- Post #2
- Forum: Under Construction
-
My 97 project
Everything is finally primed and blocked Started with this had 3 coats of factory color.- Magicmantx
- Thread
- Replies: 15
- Forum: Under Construction
-
Your Vehicles as they sit now....
Getting close to paint finally- Magicmantx
- Post #1,973
- Forum: Member Photos
-
Please need help
I'm sure there is a brake pressure switch somewhere. maybe near the master cylinder- Magicmantx
- Post #2
- Forum: General Discussion
-
What did you do to your OBS GMT400 Tahoe/Yukon Today?
Still sanding- Magicmantx
- Post #6,178
- Forum: General Discussion
-
NEW GUY HERE Nothing to see
Just another Newbie. I just picked up my 2017 Z71 yesterday after a 1500 mile road trip looking at everything from N Arkansas to Houston Tx then Dallas to Oklahoma City . Finally was about to give up and just go back home when I took another look at one listed that really didn't have a lot of...- Magicmantx
- Thread
- Replies: 5
- Forum: Introduction
