Search results
-
How difficult is it to remove the side mouldings and badging from a Tahoe like this one?
Just removed the mouldings from my Denali, used fishing line to take them off an eraser wheel for the leftover double sided tape and a little buffing with some medium compound to blend the area- 99blackburban
- Post #3
- Forum: Exterior
-
Put up your speaker box pix and custom install pix up!
Box I just finished for a single 15- 99blackburban
- Post #135
- Forum: Audio & Electronics
-
What did you do to your OBS GMT400 Tahoe/Yukon Today?
Yes I would consider selling it pm me will see what we can work out- 99blackburban
- Post #5,941
- Forum: General Discussion
-
What did you do to your OBS GMT400 Tahoe/Yukon Today?
Cleaned throttle body,maf sensor and got my k&n installed- 99blackburban
- Post #5,939
- Forum: General Discussion
-
finally got my headline done and put in all suede
Looks good, been wanting to do mine in black- 99blackburban
- Post #4
- Forum: Interior
-
What did you do to your OBS GMT400 Tahoe/Yukon Today?
Took my stock exhaust manifolds off in preparation for my new pacesetter long tubes, then had to deal with this- 99blackburban
- Post #5,909
- Forum: General Discussion
-
24 inch wheels on obs burb
No crank needed for 24s, usually only 26s and up here's mine on 285/45/22s with a belltech rear leveling kit- 99blackburban
- Post #2
- Forum: Exterior
-
Your Vehicles as they sit now....
Snow and bitter cold here in kentucky- 99blackburban
- Post #1,615
- Forum: Member Photos
-
Double din install any tips
Metra makes a nice ddin conversion kit gives you a template for the trimming part# is 95-3003G- 99blackburban
- Post #2
- Forum: Audio & Electronics
-
New to the forums
Hello all just discovered this forum a buddy said I should post here 99 Chevy suburban lt ,from Kentucky looking forward to learning all I can- 99blackburban
- Thread
- Replies: 7
- Forum: Introduction
